Jump to content
SAU Community

Recommended Posts

Hi,

Is anyone elses boost going up a little more than usual in this current weather state? Mines nearly reaching the +7mmHG, im thinking around 10-12psi.

This is at night of course.

turn your undercar neons off and everything will go back to normal.

Its common knowledge that undercar neons will increase your boost levels, even on NA 4 Cylinder's

Link to comment
https://www.sau.com.au/forums/topic/115155-boost/#findComment-2121048
Share on other sites

You will notice more performance at night comming into winter due to the colder dencer air...

This is common for any car... Cause if the air is 10 degres cooler entering the air filter its gonna be 10 degres cooler at the throttle body (allow for some variance of course)...

This in turn will make the turbo sound different and improve performance... But i have seen boost increase under stock control or with a bleed valve....

Us with electronic boost controllers dont see these things happen anymore...

Link to comment
https://www.sau.com.au/forums/topic/115155-boost/#findComment-2121121
Share on other sites

Us with electronic boost controllers dont see these things happen anymore...

I've been told with the avc-r (electronic boost) that it can still spike.

i'm running 1.2bar of boost (17psi) and the guys who tuned it said it could spike to about 1.3bar of boost during cold weather.

Link to comment
https://www.sau.com.au/forums/topic/115155-boost/#findComment-2121213
Share on other sites

Haha, my neons are off haha. Yeh i understand the colder air theory, we all did year 12 science. But i would of thought the actuator and the wastegate would of controlled all the increase and ONLY slightly increase the boost. Isuppose thats the way it goes.

Anyways is your car doing it? for those who dont have the SPC SBC ABC PFC PFFFFFFT systems, =)

Edited by arbess
Link to comment
https://www.sau.com.au/forums/topic/115155-boost/#findComment-2121831
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey everyone,   I’m looking for some advice on replacing the timing belt on my RB25DET Neo-powered 1998 Skyline. The engine was fully built about five years ago, including a fresh timing belt, water pump, and other essentials. However, since then, the car has only covered around 2,000–3,000 miles. It’s currently making around 650hp.   Even though the mileage is low, I know timing belts have a time-based lifespan too, and most recommendations suggest changing them every five to six years or 50,000 miles. Since I’m at that time mark, I’d rather not take any risks and plan to swap it out soon.   A few things I’d like to hear opinions on: 1. What’s the best belt for this setup? Should I go with an OEM Nissan belt, or is the HKS fine-tune a better choice given the power level? 2. Would you bother replacing the idler pulley and tensioner at the same time, or only if they show wear? 3. When swapping the belt, is it necessary to lock the cam and crank gears in place, or is lining up the timing marks enough? I’ve seen different approaches, and I want to make sure I do it right.   The water pump was changed with the rebuild and isn’t run off the timing belt, so I don’t see a need to replace it again. I just want to make sure I approach this the right way.   Any insight would be much appreciated. Thanks!
    • How does this compare to the internally gated g25-550 in terms of power production at same psi and spool
    • Did you find that your voltage of the battery wasn't where it's normally supposed to be? for example on my r34, it's at 14.5v when running after a few seconds, but I noticed when I had a rough start and it initially wasn't idling correctly, the voltage on my triple gauge cluster was showing lower than usual. Seems like the alternator is starting to crap itself
    • And, given that you're in NC, go buy an LS7 or something equally sweet and piss that crappy old RB off. Or call up Wesley Kagan and get his help putting a Merc V12 into it.
    • Do a compression test, and a bore scope on the cylinder that lost parts of the plug. Chances are, that cylinder isn't so happy anymore...
×
×
  • Create New...