Jump to content
SAU Community

Recommended Posts

it stays flat. has its little jerk and then goes again but up high rpm around 6-7 you cant feel much.

i have front mount, 3 inch all the way, filter and BOV

i have a full exhaust with a shit tip from japan which came with the car.... its like an oval shape one.. pretty quiet not like a cannon..

like a stock GTR exhaust with a 4inch tip....

Sounds like the rich and retard thing.

Check out this old dyno sheet of mine. The lower line is no boost controller turned on, full exhaust, stock cooler. The upper line is 12psi of boost. See the dip in the power? It was very noticeable on the street.

post-7957-1147929277.jpg

I dont get it.... Adam... you got only 100 RWKW on stock boost?! how is that possible?!?! and only ~150rwkw on 18-19 PSI?

I used to run around 12PSI on that pheunamatical mehcnaical boost controller from SidMark on a stock exhaust and EManage. Was I restricting the power?

yeah thats it...

same as you abo bob....

thats how i feel but you can feel it bigtime on the streets....

heard it was rich too... but man i cant see from the rear mirror....

so if i was to boost my car to 12psi cooler full exhaust filter...

how much you think i can push?

or how much does everyone else push?

Edited by ZERO

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • GTSboy, thank you again. i’ve been reading all the other SAU RB25 vacuum line threads and you have the utmost patience for people asking “where do my vacuum lines go”. it’s appreciated. i did also enlist a few other RB guys local to me.  i would like to run 5 to 4. turbo pressure side to wastegate actuator. i would like to run 3 to 1. power steering air valve line to intercooler outlet. (this is how it was previously). i was told 2 is the bleed port for the boost solenoid - which i’m not running - so should be capped.   anyone see any problems with that?    
    • So yes. All of them. Something like 98% of all fuel in the USA has 10% ethanol: https://afdc.energy.gov/fuels/ethanol-fuel-basics It's labelled as like, AKI, 87, 91, 93 with an E10 or E5 or E15 label on the pump. At a certain point, it's not just "E10" instead of 91. It is 91, 95, 98, and all of them have 10% Ethanol in them. You can also get E85 and E30 which is why you do see some people rolling around with E30 tunes in them.
    • Thanks for the response. This is an 04 EP3 Type R. JDM spec. Fairly certain they're just basic BC racing coils. I do plan to keep as the ride quality on stock I've been told is pretty meh given Sydney roads. If I were to go down that avenue, does NSW require them to be a certain spec (close to original) etc?
    • Should have asked what is the car?
    • I've had two super conflicting experiences with blue slips. My 30 year old E39 waltzed through with no issues but my brother in law was knocked back on 12 y/o 3 series due to wiper blades and some cracking in a control arm bush.  What kind of coil overs? Do you want to keep them after?  If it was me I'd get some dirt cheap shocks and springs from eBay or scumtree. Not ideal but will get you over the line and might even be less than $1k.
×
×
  • Create New...