How To Setup Blitz Sbc Id-3

[Kaido_RR]

Hey,

I've just got a Blitz SBC ID-3, i have found the english instruction but i still have a few question..

car is a r33 s1 rb25det

For the 2 main holes

Which is the In and Out,

im guessing that the Actuator is In and the Out goes back into the turbo... (but does that mean the In on the box is the turbo-outlet and the out is the actuator?)

so like this digram

also the connection (tube) on the main cpu, does that go to back of the manifold and the intercoole pipe?

thanks michael

[Craved]

in - feed from the intercooler pipe or plenum

out - goes to actuator

--------

feed hole on the controller unit comes from the plenum.

i didn't get the teflon connector listed there in my kit, so i used silicon hose over the 2 hoses and clamped with a small cable tie.

[Kaido_RR]

thanks for that Craved but my turbo is not stock its aftermarket and it has an opening the same as this photo

so im assuming that i would block up the hole in the intercooler and just uses the turbo.

also for the feed hole, why does it say to uses the T-pieces isnt there only one line to the plenum (im guessing its the rear of the plenum yes?)

[Craved]

there are atlest 3 spots on the plenum you can use for a feed.

but on yours, hook up the in to the line of the turbos compressor housing like in the pic above, the out to the actuator.. you then use the boost guage feed at the back of the plenum to run the the controller box inside the cabin.