Jump to content
SAU Community

R32, 33, 34, S13, S14, S15, Wrx Leather/vinyl Seat Covers..


Jetdat
 Share

Recommended Posts

  • Replies 215
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I think maybe they should give us discounts on the handbrake and gear knob boots & door trims as they are very pricey. you can buy real leather gear knob boots and hand brake boots in our group buy for $70 for the 2!

And in regards to postage

Funky is coming up to syd so the syd people can save themselves $50

Link to comment
Share on other sites

i will be going in tomorrow(they were not at the factory today) and showing them our order to date and get an idea of what discounts, if any at all, they can give us...

Yeah l was going to go there today to discuss with them how to go about mine, as the Stagea's will need to be custom made. Plus l wanted to check out the black & crinkle, as l'll prolly go that look with grey stiching. That and there's a centre console l want to get covered if l'm going all black.

Is sounding good though, if l can get the doors for a little less l'll be damn happy, coz atm $400ish for the seats seems a pretty good deal.

Link to comment
Share on other sites

Jetdat, could you confirm these two colours for me on this combo?

leather2.jpg (are they M012 + M001)?

I'll make my decision on the other thread when we firm up some pricing on options etc.

umm i am not sure if M012 is ivory or cream....that pic is ivory inner and black outer....

i will find out morrow, for now u can use that...

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share




  • Similar Content

  • Latest Posts

    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
    • Id like to race in the US i think alot of those track would suit me   For the s15? Youd be stuck between club sprint and the new Open Am wouldnt you depending on how much interior you have left in
×
×
  • Create New...