Jump to content
SAU Community

Recommended Posts

Bought these about 10,000km ago.

Both front and rear struts for sale as complete units. Want exchange for stock suspension struts (need something to drive the car around with). Rear shocks also have new dust cover kits

Heights are already set at nice streetable heights so no need to change them, just 3 bolts to remove each strut and repalce, off you go. Much easier than what I did.

All 4 as a package, cost me $1300 new and I've assembled them and trial and error'ed the heights, asking $800 + freight the lot WITH SWAPOVER for stock suspension struts.

Will have pictures up in the next few days.

Phone:0439 909 610

Link to comment
https://www.sau.com.au/forums/topic/124755-bilsteinwhiteline-suspension-struts/
Share on other sites

Hi

Any reason why you are selling your existing suspension?

I was also going to put in whiteline bushes into my GTT but if your selling them because they arent that good then I might reconsider.

Thanks

Champ, This is the best handling suspension package I have encountered in my life for the street.

The quality and engineering behind this entire kit is beyond imagination for the cost.

I am not selling it because of poor quality, rather my car is being returned back to standard in preparation for some repairs and then sale (Loose less with stock parts back on)

I 100% back this entire kit and I am certain you will be 100% satisfied with its performance. Infact, the next car is going to be an R32 GTS4. It currently has a full suspension package which I am removing to replace it all with the full R32 kit

Regards,

Alex

  • 8 months later...
Bought these about 10,000km ago.

Both front and rear struts for sale as complete units. Want exchange for stock suspension struts (need something to drive the car around with). Rear shocks also have new dust cover kits

Heights are already set at nice streetable heights so no need to change them, just 3 bolts to remove each strut and repalce, off you go. Much easier than what I did.

All 4 as a package, cost me $1300 new and I've assembled them and trial and error'ed the heights, asking $800 + freight the lot WITH SWAPOVER for stock suspension struts.

Will have pictures up in the next few days.

Phone:0439 909 610

Hey just wondering where the struts are located?

Also what your selling, its that everything needed to lower the car? eg. don't need to buy springs or anything (sorry n00b here :bunny:)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...