Jump to content
SAU Community

Recommended Posts

  • Replies 112
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

nah it sounds about right, the rev limit is at 7000 but what the ecu see and what the tacho see are two different things. it probably did reach 7800 at once stage, if you just keep bouncing and trying to make it, it will probably get there. i also get 3 different rev and speed settings from hand controller, rsm and stock tacho and speedo

I got about the same k's as you paul. I filled up in hoppers before i left on sat morning n got 200k's n used 1/4 of a tank when we got into shep, then had half a tank left after D4D and got home just under 1/4 left and had done 430k's so i would have gotten around the same as u easy.

For sure mate! It'll be great to see the old holden sideways. Just make sure it's got a locked diff and you'll enjoy yourself. Just do it for the fun of it, because your car will be the limiting factor. Give it a go!

haha, ya the car is gonna be a big factor in being gay, altho will be out there to have a ball, not to compete, its all about the fun, and socialising etc :)

its got a fkn tite assed mechanical lsd in er, recently rebuild n shit ... its nice :wave:

mite take a while, damn money holding me back !!!

Go the Lada!! :D

ladaburnoutrf6.jpg

So who photoshopped the smoke in there :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The spray cans were in the "Kiln" room whilst I was preping the parts,  so probably around 2 hours to get them warmed up, the kiln room has 3 small ovens running at 100°c, 3 medium sized ovens running 100°c, and the large one I used running at 80°c, the room itself was about 28°c, I also spent a bit of time taping up the parts in the room as well, and by the time I was done I would assume that the parts were around that 28°c As for power, I expect a couple of Killerwasps up high would be achievable with the current mods, I'm still running the MZR 2.0 intake and throttle body, and there is a slight mismatch with the 2.0 intake (smaller) and 2.5 intake ports (larger) on the head, this intake is matched and specifically designed to fix this issue with the ports mismatch, the throttle body is also a couple of mm larger, OEM is 65mm, the Bosch is 68mm In the end it will look "prettier" than the molded plastic thing that is the OEM MZR 2.0 intake As for the LSD, it's the OEM Torsen which works fine for what I use the car for, plus, basically no maintenance apart from the occasional oil change
    • I was at Tunehouse in Marrickville (great team over there really know their VR's) , and I spotted this Very clean R35.  
    • Mate , I have the same issue right now with the exhaust noise , if you can tell me what your local guy did , I'll talk to my guys and see if they can do the same. Power is good but it just too loud when put it down. 
    • The other trick I've found with wrinkle black is to put the can in hot water for a bit to warm the paint up, and to pre-heat whatever you're painting. It'll be interesting to see if you pick up any power with the intake, following with interest. Got a proper lsd for this?
×
×
  • Create New...