Jump to content
SAU Community

Wtb: R33 Brake Calipers

Flyen

By Flyen,
in Wanted to Buy

 Share

Recommended Posts

ForcedRex7 Rookie

ForcedRex7

Posted
Posted (edited)

I have some front ones with pads, clips etc for $270 plus post. And even have some rotors that have NO grooves in them and are almost as new thickness, minus the surface rust. Car they came out of only did 38,000km.

This stuff was sold but someone in W.A didnt want to pay for the whole postage cost to where they live.

I'am in Adelaide.

Edited by ForcedRex7
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • TurboTapin
      Fake ARP bolts?

      By TurboTapin · Posted

      Yes sir, that was me. Fake ARP's are also a thing over here in Canada and we only order from reputable dealers. It's sad that even simple things like bolts and hoses are now also being copied... anything to make a dollar.  Story time. Like all cheap crap from China, it's even an issue with firearms. Roughly 15 years ago, I purchased a new cheap Norinco 12g shotgun. First time out in the bush with it, while firing, bolt assembly didn't lock and it fired out of battery. The receiver also being cheap steel, basically exploded in my face. I was lucky to be wearing eye protection. Long story short, don't buy Chinese junk. Also Norinco being state run and their only military arms producer, if ever they do try and take over a country, don't worry about it lol. 
    • rbs30
      RB gearbox options

      By rbs30 · Posted

      Newcastle NSW
    • ck_chino
      Nismo copper mix twin “pull” pedal height engagement

      By ck_chino · Posted

      Installed  Nismo coppermix twin competition spec last year in my bnr32 with pull trans with Oem slave cylinder. The point at where the clutch disengages/enages is right at the top of the clutch pedal, meaning I barely have to push the pedal down for the clutch to be disengaged.  You guys that have the same combo are you experiencing this high pedal bite point??   Secondly I’d like to have the disengagement point lower meaning I have to push the pedal more(further not effort)for it to be disengaged.  I’m thinking to use a Nismo big operating cylinder(bigger bore at 13/16 vs Oem 3/4) which will require more pedal stroke to get the equivalent movement at the clutch fork. But I see Nismo web site says not to mix these 2 as the Nismo big operating cylinder doesn’t have enough stroke to disengage??? Any folks run both the coppermix twin pull with Nismo cylinder??    Thanks in advance for the replies but prefer only guys with pull clutches to respond. thanks     
    • Watermouse
      RB gearbox options

      By Watermouse · Posted

      Any chance u could let us know where your based ?
    • rbs30
      RB gearbox options

      By rbs30 · Posted

      That’s a great deal and I would jump on it if you were closer. Melbourne is a bit of a hike for me though unfortunately 
×
×
  • Create New...