Jump to content
SAU Community

Recommended Posts

Hi Guys, I just replaced my O2 sensor on my R32 GTS-t with an EL Falcon replacement as reccomended here but it is idling like crap so I unplugged it and it is fine again...

I am guessing that I got the wires wrong.

The R32 Sensor has Black, Red and White

The EL Falcon Sensor has 2 White and a Black.

I am guessing that the black goes to black? The others I just copied the output from the R32 sensor (red was top right and white was top left)

I am guessing I have them wrong, can someone tell me what is what??

Thanks!!

Todd

Link to comment
https://www.sau.com.au/forums/topic/127517-el-falcon-o2-sensor-on-r32-gts-t/
Share on other sites

My Ford sensor had two white and one black. The black was the signal wire, and the two white were the heater wires.

My R33 plug had the same thing, but different colours. Could have been two black and one red. Can't remember, but they all hooked up fine.

Thanks but I don't think so. once it started playing up (after I put on a new dump pipe), I unplugged it to bypass the problem.

Thanks for the info about the wires. As stated the ford one that I have also has 2 white and 1 black wires.

The r32 sensor has a black, red and white. IS ANYONE ABLE TO TELL ME WHAT IS WHAT??

Thanks for your help so far!

Maybe someone adjusted your idle air control valve when your 02 sensor was dead? So when you plug it in, it's running correctly, but your adjustment is outta whack? Dunno. Just a guess.

I would wager a guess that the black and red both go to black, and your white wire goes to the black on on the 02 sensor. Still, dunno... someone will give you the answer though! You definately got the right one for your car, yeah?

Todd even though it is a cop-out, there are only three different ways to connect the sensor, given that the signal wire can only go in three different terminals and the heater wires are irrelevant. (and as Randy said, black = signal, white = heater). If you don't receive an answer, try trial and error and use a voltmeter to test the signal output. If you're in Sydney I can help out with a Consult cable.

As an outside chance, did you reset your ECU after installing? You'll need to clear the fault codes otherwise the ECU will most likely consider the sensor to be still broken and it'll revert to the run-rich ECU maps.

So I am guessing keep it how it is, plug it back in and reset the ECU? If I still have the problem I will try swapping them around!

Would still be great if someone could tell me for sure... surely someone has done this to an R32 before.

Thanks guys!

I've changed my O2 sensor with an EL Ford one as well, my experience with connecting things up was the same as Randy's. After an ECU reset the car ran fine (and still does). :) Would it be fair to say that the middle of the 3 wires is the signal, the other two are the heater wires? (pretty sure that's how mine was).

the el 1 is cheaper, but you have to wire it up.

i haven't done the research, but you have to take into account that if the sensor has different resistance and power then it can give the ecu false readings. for the extra money it is worth sticking with the proper one.

i know that the r33 unit is the same as used in the sr20 in the SSS pulsars and nx coupes (same part number). not sure if the rb20 is the same, but i think it might be.

  • 2 weeks later...

Quick question.

My car has an aftermarket computer. (Link)

Recently it has suddenly started getting worse fuel economy. Could it be my oxygen sensor, or does my ecu somehow not utilise the factory O2 sensor anymore?

It's probably a basic question, but I'm not mechanically minded!

Please reply, I'm sick of getting ~100kms less per tank then I was a few months ago!

If it's not likely to be the sensor, what else could be causing my sudden pathetic fuel economy? It literally turned bad over night.

Thanks :ninja:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pfft. As if I'd ever point a high pressure washer at my car.
    • The nature of my commute has changed. Way back then it was traffic lights all the way, for ~28km. It sucked. When they finally stitched the expressway together I could do a good 15+km of it at a steady 80-100 with no stopping. That alone has gotten me down to flat 10s. Prior to that it was mid-high 10s. I can't remember the delta that I saw when I got the idle down. It was only ~150 rpm, because the idle speed was never terrible, but for the delta in consumption to be noticeable it would have had to have been at least 0.2-0.3 L/100km - which is not to be sneezed at when it comes for absolute free. It's only about 50L per year, but that's ~$100. A few extra pizzas is always welcome. Note that I have a record of every tank of fuel that has ever gone through my car except for a handful put in by someone else, like my mechanic. I can show you the difference between stock RB20 and tuned RB20, stock RB5Neo and tuned, winter and summer fuel blends, winter and summer fuel blends when the ambient temperature is not appropriate for the blend, working O2 sensor, blown O2 sensor, boosting f**k out of it and frightened to boost it because it is pinging, and so on. OK, I probably can't do all that now with 100% clarity - but at the time when any of those things were in event, you could see it in the records. There's 25+ years of simple tank after tank records, so you have to look for landmarks to work out approximately how old any single record is. What's really important is the meta data and that lives in my head.
    • If you're claiming the issues are not skyline specific, then either the USA is living in the 90s / early 2000s, OR you have the issue of "survivor bias". Which is you're mainly hearing and listening to those with terrible experiences, and haven't found the guys who have cars with good decent builds and no problems. It happens in AU too, that plenty of people keep having issues, and they keep going to the workshops that are known to be shit "because I read on the internet". Even worse, are those who keep posting on the internet as though they know for a fact what something is, when they've never touched/looked at said item in their life, and again are making assumptions, based on something they read, or because it's a certain way in other cars. It's even funnier when those same people debate the facts with the people who've lived and breathed this stuff for over 15 years. Example, I've had someone tell me you can't do something with a Skyline, because they read it on the internet, except I can tell they're wrong, as I did that exact thing back in 2008 with my Skyline.
    • The funniest part I saw, was someone would bitch and moan on FB about something, Andy would be the one to respond, asking for more info, if he could contact them, what the engine setup is, what their config file was, and 95% of the responses were people just going "der! It doesn't work" and Andy going "What doesn't work?" And then going "The firmware!" And they'd go around in circles as no one could ever give information, and Haltech couldn't fault things on the bench, (especially when people wouldn't give any specifics).   Many moons ago, when Andy was back at e420c stage, he reached out to me, and asked me to test different plug and play looms for him (already had an e420c in the car on his V1 PNP loom). And he kept asking me, as I was competent enough to be able to give him some specific feedback on what was/wasn't working, how to replicate the faults etc, and work through things with him. Most people are terrible at answering the questions they're asked, or being able to provide quality feedback other than "it doesn't work".
    • I say it often, none of this stuff is really Skyline-specific per se. But in general there's not a lot of people who actually know what they're doing. A lot of people charging like they do. Agile software development probably isn't the greatest idea for an engine controller.
×
×
  • Create New...