Jump to content
SAU Community

Recommended Posts

i dont really have th cash to get a full kit and a full respray so i was thinking of maybe just getting a front bar for now. but im a bit worried it might look un even and stupid.

i think ive seen a few cars with just front bars and they look okai. maybe it was a kit i aint sure. newai what do u guys think?

that just a GTS-T? rims are hot! gotta love the GT4's

exhibit a, yes looks bad without have the cars kit low all the way round... i'm looking for skirts and diff rear bar... not many nice kits for the 34 unfortunately...

clean1.jpg

that just a GTS-T? rims are hot! gotta love the GT4's

If its just a GTST they've gone to alot of trouble changing to S3 xenons, GTR side indicators, badging, pumped guards, rear wing, M spec seats and a midnigh purple paint job :whistling:

that just a GTS-T? rims are hot! gotta love the GT4's

exhibit a, yes looks bad without have the cars kit low all the way round... i'm looking for skirts and diff rear bar... not many nice kits for the 34 unfortunately...

clean1.jpg

Nice I like what you've done there with the front end.

I have what you're looking for side skirt wise I just got them fitted to my GTR this week after having them in the garage for about 10 months and i wet myself when I saw them. They came from Japan and cost a packet (mostly in shipping costs) but theyre worth it. I'll get some photos tommorrow and show you.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...