Jump to content
SAU Community

Wtb:the 2 Air Intakes From Front Bar For R33 Gtr

ruppertthebear

By ruppertthebear,
in Classifieds

 Share

Recommended Posts

ruppertthebear Rookie

ruppertthebear

Posted
Posted (edited)

Hi im new to this site, just got a r33 gtr marine blue, but the front air intakes were missing want to replace and paint any help would be great, tar jay

post-30644-1154133993.jpg

Edited by ruppertthebear
  • 2 weeks later...
N1GTR Grand Master

N1GTR

Posted
Posted

Ring JustJap on (02) 9545 0532 and ask for R33 N1 front bar vents, they are on the justjap site aswel, go to HERE and they are the VERY last item on that page, make sure you specify R33 when you ring them as the R32 ones will look shit on an R33. Cost is around $145 a set

Postage wont be much either as they're not a big heavy item

(Nice GTR By the way)

 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Shoota_77
      Shoota's R33 GT-R RB30/26

      By Shoota_77 · Posted

      Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • soviet_merlin
      NC MX5

      By soviet_merlin · Posted

      A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
    • MBS206
      Shoota's R33 GT-R RB30/26

      By MBS206 · Posted

      I was more thinking so it doesn't flop around as much rather than for rotating it. Once you have the balance right, it should rotate well enough, depending on how much resistance there is on the pivot. I think you said the pivot point was on a bearing though didn't you?
×
×
  • Create New...