Jump to content
SAU Community

Recommended Posts

from my knowledge of the rule its ok as the pods would be considered 1 intake mod. if you were to change the intercooler that would count as two intake modifications. best to ask vic roads as a lot of their rules are full of grey areas and exceptions

when i spoke to the EPA last about aftermarket front mounts, they said as long as you can prove it is within stock dimesions then its fine. But i couldnt be assed taking off the front bar to measure up the cooler and just used a stock air box instead!

Im sure this has been asked before, but would i get away with a enclosed POD? Legally? Its still a modification but.. not off the shelf, and its roadworthy so.. any ideas?

the pod doesnt have to be enclosed as far as i'm aware (although its useless if exposed to the engine bay anyway)....

As long as its secured to the car, and is the only intake mod, its legal

Someone from EPA mentioned if you have a Pod Filter it has to be the Dry kind not the Oil Soaked ones. Anyone confirm this?

The Reason why I ask is because everytime I ring up I get a different response.

Edited by beefy

what if you have a pod in and enclosed box that you cannot see, and a cooler, what can be done ?

When i called the EPA regarding this i was told only an exposed pod OR a cooler. Unless the car comes with a factory intercooler then you can have a pod as well.

Someone from EPA mentioned if you have a Pod Filter it has to be the Dry kind not the Oil Soaked ones. Anyone confirm this?

The Reason why I ask is because everytime I ring up I get a different response.

Oil Soaked pods are illegal, the dry kind are fine.

what if you have a pod in and enclosed box that you cannot see, and a cooler, what can be done ?

When i called the EPA regarding this i was told only an exposed pod OR a cooler. Unless the car comes with a factory intercooler then you can have a pod as well.

Having a pod, whether it be enclosed or not and a Intercooler thats not stock or is relocated is illegal.

A pod with a stock cooler is legal.

A FMIC and stock airbox is legal.

You could get alway with an enclosed pod if the box looked factory, but its still illegal.

Cheers

Edited by stealth01
  • 3 weeks later...

If that's the case, I need some help. I have actually 'misplaced' my stock air box in my garage (it happens). Can't find it anywhere now. And I have ordered a new FMIC recently. Since I still want my mods to be legal, I want to replace my pod with a stock air box again. Anyone out there willing to sell me their stock air box. I have a R32 GTS-T and I live in the outer east (Knox area).

EPA Mod Rules Extract February 2006

© Intercoolers that are larger than standard or have a different mounting location or are added where none were originally fitted, are permitted only if no other changes to the intake system have been made. In other words, you may have a pod filter or modified/added intercooler, but not both.

Any sensors integral to the original intercooler or intake system must be retrofitted and be in the correct location. Note: aftermarket turbocharging kits that include intercoolers that have been type tested (ADR certified) for the model vehicle are permitted. Documentary proof must be retained to substantiate this.

(b) Dry element pod type air cleaners are permitted on EFI vehicles. Oiled, oil-soaked or fluid-treated elements are not permitted. Any sensors integral to the original system must be retrofitted to the same approximate location.
Variable turbocharger boost valves (‘boost controllers’) or other means of altering boost levels are not permitted unless part of an original manufacturer’s fitment. ‘Blow off’ (‘pop off’) valves must be plumbed back into the system. Atmospheric venting is not permitted. External wastegates are not permitted.
Non-original electronic chips or computers, whether fitted as a direct replacement or in a ‘piggy-back’ configuration, are not permitted to be used in an engine management system unless it can be demonstrated that their installation and use allows the vehicle to meet the appropriate ADR. They must also be sealed or otherwise constructed so as not to be reprogrammable.

So who here can say they do not breah any of the above rules?

With my new setup, me.

Either way, its not a question of who can pass or not.

The rules are there, they are readily accessible.

So next thread about "can i have a pod" gets locked :(

hehehe...i wold have thought most ppl would have aftermarket ECUs and boost controllers... Pods and ICs are visible and hence gain the majority of the attention. Just don't drive like a hoon or be on P plates...The insurance companies don't seem to care much, having made a massive claim with most of these known on their books they still payed out no quetsions asked. I would have thought they would go to town on this stuff, maybe they do sometimes and I was just lucky.

hehehe...i wold have thought most ppl would have aftermarket ECUs and boost controllers... Pods and ICs are visible and hence gain the majority of the attention. Just don't drive like a hoon or be on P plates...The insurance companies don't seem to care much, having made a massive claim with most of these known on their books they still payed out no quetsions asked. I would have thought they would go to town on this stuff, maybe they do sometimes and I was just lucky.

Has anyone experience problems with their insurance companies from their mods?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You ask for things. You specifically state you want responsiveness. A link was provided for a far superior, more responsive option. Find a MX5 workshop that will install it for you. Maybe MX5 Mania will throw on the Fab9 kit. It seems they want to charge almost 14K installed for their kit, so if they charge you $6K to install the FAB9 kit then you'll be ahead? Though really, the 2.5 with a 2860 running low boost will more or less feel as good as anything else. It's a lot of displacement and a small turbo. Think of a more modern RB26 with one stock turbo :p TBH, truth be told I've been driving my own car, and use about 50% throttle at most for 99.9% of the time. Mr Bogan is likely similar so this is all going to be semantics for the use case he actually has. (He'll be happy with anything relative to now) However, the EFR is hands down far superior in this use case. You really, really, really, really do notice it over the Garrett or equivalent.  
    • You are correct, the earlier the torque, the earlier things snap
    • Gents, it will be getting the MX5 Mania kit and the 2.5 will be staying where it is My query was about the 0.64 or the 0.86, whilst the 0.64 might spool a bit faster, would the 0.86 be better IRT EGT and mechanical sympathy, with only a small difference in spool And as I assume I won't need alot of boost to get to 200kw, probably around 10 psi, and with max rpm at 6500, would high EGT even really be a issue with a 0.64 I'm heading into MX5 Mania at the end of Jan to discuss the install, so any info is welcome prior to that Basically have a chat and book a time so they can throw on the turbo kit, and fit a oil cooler with a thermostat, drive in drive out of course  In other news: just finished cleaning the car inside and out, it's now all ready to get covered in bugs and dirt driving to Goulburn tomorrow to lunch,  and go for a stroll along woolondilly River with the daughter and her boy, and of course, visit my grandcats and my new grandpuppy 
    • Sounds like it has an actual problem with mode select doors, or something.
    • Hope your all having a mean Xmas! If anyone happens to know any trick to using the insanely complex climate control system, I cannot get it to not be on dual zone no matter how many times I deselect it (will say it's not but both vents blow different temps). Also one side is always hot, one always cold 🤷
×
×
  • Create New...