Jump to content
SAU Community

Recommended Posts

HI! everyone i got an R33 GTSt wrecking at the moment ,i havnt made up a list yet or price will do that on tuesday afternoon.I will take any inqurie if anyone are chasing for R33 GTST parts till the list come up .the car been hit on the left front bonnet,guard and LH door are no good.that all for now list be up on tuesday afternoon.

pm me or email me on [email protected] or call on 0415642296.din.

post-21589-1154426805.jpg

post-21589-1154426979.jpg

post-21589-1154427012.jpg

post-21589-1154427031.jpg

post-21589-1154427051.jpg

post-21589-1154427086.jpg

post-21589-1154427108.jpg

post-21589-1154427169.jpg

post-21589-1154427190.jpg

post-21589-1154427220.jpg

post-21589-1154427346.jpg

post-21589-1154427425.jpg

post-21589-1154427573.jpg

post-21589-1154427599.jpg

post-21589-1154427668.jpg

post-21589-1154427752.jpg

post-21589-1154427773.jpg

post-21589-1154427853.jpg

post-21589-1154427884.jpg

Edited by dinzlr
Link to comment
https://www.sau.com.au/forums/topic/128339-wrecking-r33-gtst-whole-cars/
Share on other sites

  • Replies 53
  • Created
  • Last Reply

Top Posters In This Topic

hmm dude would you have the plastic covering bit on the side of the driver seat??

You know that black looking thing, that covers the reclineably push lever thingy??

You know what im talking about?? Its just one bolt..

20bucks??

Edited by siddr20

Hey mate,

Are you willing to sell parts off the engine, or are you planning to sell it whole?

As I'm after the "U" shaped rubber hose that goes between the two vents on the rocker covers, and also the knock sensor loom.

Cheers, Ryan

hey dude you would have it.. I can see bit of it from pic 2..

look at the driver seat. Look at the bacl thing under it sorta..

You know when you put the lever up so the seat reclines..

Hmm i dont have camera to take a pic of mine..

look at pic 2, you can see it..

Edit: This pic: http://www.skylinesaustralia.com/forums/in...st&id=49430

Edit 2: How much for that gtr wing?? Cheers

Edited by siddr20

Do you have the plastic bit under the drivers side? Under the steering colum, the plastic that covers the fuses and the wiring under it etc.. $10?

Driver side floor mat?

Power steering pump? (Just want a rough est on price)

And if you are wreaking engine (though I doubt it) CAS Whole unit.

Cheers

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I replaced the whole clutch line with the chase bays braided hose, I think it removes that loop, is it the short hose that comes immediately off the slave or is there a drawing in the manual to find what you’re referring to? It was just re-bled when I upgraded to the nismo slave, old slave worked fine but I thought that might help, didn’t change a thing. It’s like the first half of the pedal is pushing air and then when it finally actuates the master the friction zone is tiny. Makes it practically impossible to launch the car
    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
×
×
  • Create New...