Jump to content
SAU Community

Recommended Posts

Is the rear exhaust photoshopped??? those cannons are huge for dual ones!!??

I wish it was. I have another exhaust here to put on it just need to get another rear bar, cause they have cut this one to get the exhaust in there.

I think it looks mad, I want dual big ass pipes.....maybe not that big. hows the noise lvls?

The wheels actually look OK to me, what size are they? and what have you done with the 5 spokes you had on it?

It's pretty loud.

The new wheels are 18x8.5 +22 (with a 25mm spacer) front & 18x9.5 +22 rear. The Enkei's are going back on my R34.

Just a question / some help.

does anyone have a pic of a series 2 and a series 1 r33 taken from directly behind?

Is there any differance in the ass end between the series1 and 2?

the garnish strip (with the word "skyline") is clear and convex on the s1 and concave/body coloured on the s2. other than that, exactly the same. wings are square on the later cars (late s1 too) but they are changed more often than the garnish

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey everyone,   I’m looking for some advice on replacing the timing belt on my RB25DET Neo-powered 1998 Skyline. The engine was fully built about five years ago, including a fresh timing belt, water pump, and other essentials. However, since then, the car has only covered around 2,000–3,000 miles. It’s currently making around 650hp.   Even though the mileage is low, I know timing belts have a time-based lifespan too, and most recommendations suggest changing them every five to six years or 50,000 miles. Since I’m at that time mark, I’d rather not take any risks and plan to swap it out soon.   A few things I’d like to hear opinions on: 1. What’s the best belt for this setup? Should I go with an OEM Nissan belt, or is the HKS fine-tune a better choice given the power level? 2. Would you bother replacing the idler pulley and tensioner at the same time, or only if they show wear? 3. When swapping the belt, is it necessary to lock the cam and crank gears in place, or is lining up the timing marks enough? I’ve seen different approaches, and I want to make sure I do it right.   The water pump was changed with the rebuild and isn’t run off the timing belt, so I don’t see a need to replace it again. I just want to make sure I approach this the right way.   Any insight would be much appreciated. Thanks!
    • How does this compare to the internally gated g25-550 in terms of power production at same psi and spool
    • Did you find that your voltage of the battery wasn't where it's normally supposed to be? for example on my r34, it's at 14.5v when running after a few seconds, but I noticed when I had a rough start and it initially wasn't idling correctly, the voltage on my triple gauge cluster was showing lower than usual. Seems like the alternator is starting to crap itself
    • And, given that you're in NC, go buy an LS7 or something equally sweet and piss that crappy old RB off. Or call up Wesley Kagan and get his help putting a Merc V12 into it.
    • Do a compression test, and a bore scope on the cylinder that lost parts of the plug. Chances are, that cylinder isn't so happy anymore...
×
×
  • Create New...