Problem With Bov

[absmith]

ok just got a g ready bov fitted it's set up as a atmo but can be plumbed back but if i rev it hard at idle it drops the idle so low it almost turns off or does turn off any one got any ideas wat could it be or should i just run it as plumb back.

thanks aaron

Edited September 1, 2006 by absmith

[KeeFy]

Check that ur installation is correct and that ur piping to the bov is not leaking. Another thing is to increase airflow by adjusting the aac valve located at the intake manifold. Solved the problem for me.

[Munkyb0y]

everyone knows plumback is the way to go on rb25det's.

i had mine atmo venting, and it never showed any real probs, but then i plumbed back, even steadier idle.

[Kaido_RR]

is the bov setup correctly?

also adjust the spring in the bov make it tigher it may be too loses