Jump to content
SAU Community

Recommended Posts

Problem Lies in tha ti had to replace my vee port BOV with a plumb back system for defect reasons cough cough. Now the thing is that since i did this hooked up the plumb back system correctly, started up and rough as guts idle very low almost sounds like one of those very sick sounding datsuns that some idiot put cams in, very very bad idle hunting and cant seem to work out wtf is going on,

Tried adjusting it both ways to no avail or resolution, as being one of them turbosmart type 3 plumb back bov's, all lines are hooked up and everything,

If someone might have an answer that would be great, Also smells like it is running slightly rich aswell??

I was thinking air leak somewhere but not sure?

Or please dont tell me (well do) that i need a retune of the PFC to overcome this annoying problem,

Cheers and thanks

Adam

i think you would have , but have you reconnected it to plum back into the turbo intake as that will make it

run like a datto

cheers

Would have which? to do retune or air leak, if someone aswell have experienced this that would be good and yeah its plumbed back into the turbo intake after the AFM, bit confused?

Cheers adam

Hoping for a reply asap as need car running back to normal by well asap

Cheers

Dont worry have isolated the problem, lesson learned never try to do repairs in the dark that is forsure, stupid vacuum hose to the (i think) surge tank or that black tank next to the filter with 3 top hoses

Cheers guys anyways

Adam

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • HKS trigger kit should be very easy to integrate with a Link. It's a 36-2 crank trigger. Hard part is finding the motivation to take off the timing belt and everything on the front of the engine to install it. You also need to cut out a hole in the oil pump housing so the sensor can read the trigger wheel. Changing out the cam sensor for a 24 tooth setup is probably good enough but as others have mentioned depending on what underlying assumptions are changed it becomes more of a problem. Reading the crank state off of the cam is an abstraction that works in the general case, but if you have an edge case it makes less and less sense. There is a GTX2860 gen 2 that can take a compact 5 bolt housing so it's direct bolt on but I'm not 100% sure of what's involved. Peak compressor efficiency drops off a bit on these turbos vs -5s, 77% vs 73% but you get way, way wider region of operation. The -5s have a really strange surge line in their compressor map that is all over the place. If you think the hot side on the -5s aren't open enough you can try the Tomei T550B turbos which a local tuner seems to be happy with:
    • i need a complete tail light for my R33 GTR if you have please let me know.
    • I need a great maintenance workshop around Idaho, if you know one please let me know..
    • Hello friends, i have a good friend in Canada that looking for a good condition 1993 GTR around him please if one or know someone around you that is willing to let it go please let me know so that i can inform him.....Thanks
    • I'm mark from Idaho.
×
×
  • Create New...