Jump to content
SAU Community

Recommended Posts

First, I'm trying to figure out if the 280ZX rear shocks will fit on a DR30... The rear control arms look very similar and the used shocks I purchased seem to be destroyed on one side in the rear. So, I need to replace them with something else, and since I'm in the US, it has to be something found in the US...

Also, I need rear badges for my car before September 30th (which is the big yearly Japanese Classic Car show, where I'll be the only DR30 Skyline :P)... I'm looking for the rear "SKYLINE" and "DOHC Turbo RS"... Does anyone have some used ones sitting around they could sell me?

First, I'm trying to figure out if the 280ZX rear shocks will fit on a DR30... The rear control arms look very similar and the used shocks I purchased seem to be destroyed on one side in the rear. So, I need to replace them with something else, and since I'm in the US, it has to be something found in the US...

Also, I need rear badges for my car before September 30th (which is the big yearly Japanese Classic Car show, where I'll be the only DR30 Skyline :ermm:)... I'm looking for the rear "SKYLINE" and "DOHC Turbo RS"... Does anyone have some used ones sitting around they could sell me?

I can give you the SKYLINE badge, but DOHC Turbo RS is a bit like rocking horse sh!t & hen's teeth.

I have a new ex Japan DOHC RS badge, but I sold the only turbo version I had to a mate on the Gold Coast.

Cheers, D

First, I'm trying to figure out if the 280ZX rear shocks will fit on a DR30... The rear control arms look very similar and the used shocks I purchased seem to be destroyed on one side in the rear. So, I need to replace them with something else, and since I'm in the US, it has to be something found in the US...

Also, I need rear badges for my car before September 30th (which is the big yearly Japanese Classic Car show, where I'll be the only DR30 Skyline :ermm:)... I'm looking for the rear "SKYLINE" and "DOHC Turbo RS"... Does anyone have some used ones sitting around they could sell me?

How much do you think you will pay for a set of rear Orange Koni's in the US?

As far as I know, some of our spring makers use 240Z/260Z rear spring specs for 30mm lowered R30, but the shocks I cant help you with.

If they're an eye bottom mount & same top, the top plates can probably interchanged, but I would be surprised if they were the same length.

R30 rears are minimum length 20.59 inches (centre of eye to centre of mount plate when compressed), Stroke 6.89 inches

Hope this helps.

Cheers, D

How much do you think you will pay for a set of rear Orange Koni's in the US?

As far as I know, some of our spring makers use 240Z/260Z rear spring specs for 30mm lowered R30, but the shocks I cant help you with.

If they're an eye bottom mount & same top, the top plates can probably interchanged, but I would be surprised if they were the same length.

R30 rears are minimum length 20.59 inches (centre of eye to centre of mount plate when compressed), Stroke 6.89 inches

Hope this helps.

Cheers, D

Heh, even the Skyline badge would be good enough... Would you ship to the US?

Now that I think about it, the top rear shock mount on a DR30 is probably higher than on a 280ZX so length of shock would probably be an issue... Are DR30 Shocks widely available in Australia/NZ?

Heh, even the Skyline badge would be good enough... Would you ship to the US?

Now that I think about it, the top rear shock mount on a DR30 is probably higher than on a 280ZX so length of shock would probably be an issue... Are DR30 Shocks widely available in Australia/NZ?

I will, give me an adress and I'll post it to you.

I have a set of NEW Orange adjustable Koni's, front & rear, (front inserts still in the box they came in) that are available, that's why I asked what you could expect to pay in US, so maybe we could work out a deal that gets you sorted out.

Cheers, D

I will, give me an adress and I'll post it to you.

I have a set of NEW Orange adjustable Koni's, front & rear, (front inserts still in the box they came in) that are available, that's why I asked what you could expect to pay in US, so maybe we could work out a deal that gets you sorted out.

Cheers, D

What's your e-mail?

[email protected] or just send me a PM.

Cheers, D

Sorry, stuffed that up, typo?

[email protected] or just send me a PM

I wanted about AU$100 for the rears if thats ok with you, that's probably about US$75.00 or there abouts plus the freight. They are new, never turned a wheel, but were fitted to my original project car before I stumbled onto a set of coil overs.

Cheers, D

Sorry, stuffed that up, typo?

[email protected] or just send me a PM

I wanted about AU$100 for the rears if thats ok with you, that's probably about US$75.00 or there abouts plus the freight. They are new, never turned a wheel, but were fitted to my original project car before I stumbled onto a set of coil overs.

Cheers, D

Ghostrider are they reds or orange?

Ghostrider are they reds or orange?

Orange Matt, but they are the only Koni's available as far as I know, nothing else listed for them. Internally adjustable on assembly.

If you answered your phone occassionally I could talk to you about them, as I tried a few minutes ago.

Cheers, Dennis

Orange Matt, but they are the only Koni's available as far as I know, nothing else listed for them. Internally adjustable on assembly.

If you answered your phone occassionally I could talk to you about them, as I tried a few minutes ago.

Cheers, Dennis

was that you, sorry mate i'm at work i can't answer, i was asking as i have the reds in my r31 and they are internal adj, the orange are surrpost to be extrenal adj, i have the orange in the HR30 at the moment, cost about $1300 (4 years ago) for them so $100 for the rear is a brilliant price...

I can give you the SKYLINE badge, but DOHC Turbo RS is a bit like rocking horse sh!t & hen's teeth.

I have a new ex Japan DOHC RS badge, but I sold the only turbo version I had to a mate on the Gold Coast.

Cheers, D

Hey Dennis, you dont have another spare Skyline badge as well do you? I need to get a new one for my DR30.

cheers

badges found here.

http://www.r30.co.jp/goods/index.html

translate here:

http://www.google.com.au/language_tools?hl=en

aus you'll need to order them through a importer, US i have no idea, the same deal i'd say..

Edited by rsx84
Hey Dennis, you dont have another spare Skyline badge as well do you? I need to get a new one for my DR30.

cheers

I'm sure I could russle up one for you, maybe we should get together and see what else we can swap.

badges found here.

http://www.r30.co.jp/goods/index.html

translate here:

http://www.google.com.au/language_tools?hl=en

aus you'll need to order them through a importer, US i have no idea, the same deal i'd say..

They're a bomb from there and Jap postage is worse than US.

I was quoted on a GT guard badge and it went like this:

Badge 2800 Yen, Buyers Commission 1000 Yen, Domestic postage to buyer/shipping point 1500 Yen, then International Postage 1600 Yen.

All told for a badge that costs in Japan 2800 Yen, 6900 Yen (about AU$71.00)

How much did yours cost???

Cheers, D

They're a bomb from there and Jap postage is worse than US.

I was quoted on a GT guard badge and it went like this:

Badge 2800 Yen, Buyers Commission 1000 Yen, Domestic postage to buyer/shipping point 1500 Yen, then International Postage 1600 Yen.

All told for a badge that costs in Japan 2800 Yen, 6900 Yen (about AU$71.00)

How much did yours cost???

Cheers, D

not a clue, 18 months of wondering :ermm: LOL

Edited by rsx84
I'm sure I could russle up one for you, maybe we should get together and see what else we can swap.

Sounds good Dennis when I get a bit less busy with work & the kids.

Just by way of progress, I have replaced the centre console, sourced a new ashtray, lighter and socket and gearboot surround, all of which are now in. I ahave also found and out in a rear wiper motor and arm

As for the rear parcel shelf I had another made up with 6 inch speakers and carpet trim. It fits flush with the rear window and a new cover was made up for the wiper motor. When I get a chance I will take some photos.

As for the front end I put in an Alpine deck with iPod controller (iPod is hidden in the glovebox). Although obiviously not a period deck it slotted in nicely and is not over the top. The car came with Carizzero (I think that is how it is spelt) 5 inch speakers in the front doors which are reasonable.

I still need to get matching front seats and then a retrim to bring it back to original glory. The trim itself is not too bad just the tops of the rear seats have faded and the front seats are not matched in design.post-22767-1158126087.jpg

This photo was taken before I bought the car.

The boot area will also need some replacement trim and bits and pieces.

Edited by Ravenoak
Sorry, stuffed that up, typo?

[email protected] or just send me a PM

I wanted about AU$100 for the rears if thats ok with you, that's probably about US$75.00 or there abouts plus the freight. They are new, never turned a wheel, but were fitted to my original project car before I stumbled onto a set of coil overs.

Cheers, D

Emailed you a couple of days ago... Did you ever get the e-mail?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oh, that's grim. Something bad has been happening there.
    • Put an endoscope down the hole and saw this. Not quite all around the bore but a good 60% at least. Chin to the chest and towards further disappointments I guess.
    • 2 does "sort of" applies, maybe......but looking at what parts would be needed for the swap to get engineered, registered, and insured, and basically that's everything under the car, the modifications the make it legal would be problematic and horrendously expensive, all for a street car that just cruises around and hits a few twisty roads on the weekends Also, from looking at the NSW rules and Regs, with all modifications that is required just to make the car safe and not twist itself to pieces, and then actually get registered for street use, may still be impossible nowadays As for 1, when you add in a fresh engine, fresh transmission, rear cradle and diff, tailshaft, suspension, brakes, cooling, and all the other fabrication required, your probably looking at up to $100k to do it right, all for a 20 year old MX5 that is over engineered and you would never be able to actually use the power it has on the street, much like your beastie, which I love, but you actually track that thing and can use all of its powers in anger, in a safe environment  Hell, the old Bogan Cruise Ship had more power than I could use on the street, and in hindsight, I went a bit silly on that thing, it didn't really need the 500hp it had for what I actually used the car for, it was fun, but basically unusable on the street if you value your licence  As for cams, yeah, I'll probably book it in for them to get installed and tuned soonish, like next month after MX5 Mania are back at work....... and yes, I've already sent a email to bin the turbo quote and quote instead to install cams and a new Fluidampr balancer that will suit the 2.5 better than the OEM 2.0 balancer that is swapped over for the 2.5 install, as the balancer needs to get pulled to time the cams it's a while your in there sort of thing I did think a bit about flex fuel for a laugh, but being na, and no where really around locally anymore to get E85, I've binned that idea, so no sweet sweet corn smells are set for the car I wish E85 was more of a standard fuel, it's better for the environment, better for tuning, plus that sweet sweet smell we all love As for fitting in the family, that's not needed, as everyone in the family already owns a car that can seat 5 humans comfortably enough, the MX5 is "my toy" As for buying a car that is already built, nah, I would rather pick and choose my parts, I enjoy the process, and in the big picture, the additional cost is well worth the enjoyment, and the occasional frustration, I get out of doing it, albeit with other people spinning the spanners, and me, just paying the invoice 🤣
    • Excuse me, but 2) does apply 1) Would also apply if you consider how much is spent in the alternatives. Also there's the option of 3), buy one pre-built that you can put your family in (it's me, it's my car)   That said, I went on a ~500km drive the other day. I didn't use anything more adventurous than 3rd/4th gear at about ~3000RPM and 50% throttle and I was going as fast as anyone has any sense doing on a public road, with enough grip to the point where I didn't want to go any faster. I was obviously under the limit of the current car etc etc. MX5 with 2.5 N/A to achieve the same speed would be more fun for any road scenario. Maybe consider cams. I wouldn't boost it. The use case is just not there and it won't actually make the car more enjoyable unless you really do plan on wringing gears from 1st to 3rd (at least) at 100% WOT on a public road to 150+kmh.
    • Great if: 1. You had all of the money for everything else that is required  2. Lived in a country where you could actually do this and drive it legally on the road Sadly, neither applies to me As for the turbo, I am having second thoughts, mainly for engineering/registration legality reasons and insurance  Not saying I've finished doing stupid things that I probably should do to the MX5, but boost, and V8 engine swaps isn't on the cards Strange, but true 
×
×
  • Create New...