Jump to content
SAU Community

Recommended Posts

Power FC is in used condition, few minor scratches. Has basic tune for front mount exhaust and pod.

(hand controller got stolen last time i went to winton)

Reson for selling - are upgrading to RB26 in race car.

Negotiable on price for quick sale.

PRICE DROPPED FROM $600 TO $550

Edited by webber
Link to comment
https://www.sau.com.au/forums/topic/135198-r34-gtt-power-fc-no-hand-controller/
Share on other sites

pretty sure they are model specific ie 25 will only work on a 25 and a neo r34 will only work on that type of engine. the fact the rb25 injectors are side feed and the neo's are top, i think would mean it wouldnt work also.

I have a hand controller that might suit this, if it helps your sale (and mine).

http://www.skylinesaustralia.com/forums/in...iew=getlastpost

  • 1 month later...

Is the Power FC in melbourne?

Do you need the hand controller to tune the car?

Let me know asap.

Thanks

Edited by LTHL34
  • 7 months later...

Have you sold this yet if not PM me as i cannot pm you due to your inbox being full.

If it is a genuine PFC i will take it.

Thanks

Shaun

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • hrmmm , not mine , easter plans to pull engine not happening     
    • I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...