Jump to content
SAU Community

Sau Vic - Beer Garden Appreciation Day


paulr33
 Share

Recommended Posts

SAU VIC - Beer Garden Appreciation Day

When: Saturday, December 2nd 2006

Time: Meet at 12pm (lunch time) until 6pm

Where: Belgian Beer Cafe. 557 St Kilda Road Melbourne.

Duration: All Day

Pricing: Standard Bar Menu Pricing applies

Event Info:

This day is our official Beer Garden Appreciation Day. The Belgian Beer Cafe is one of Melbourne's premier beer gardens and offers a massive range of local and imported speciality beers. With plently of outdoor seating, good local folk and team SAU it proves to be a great day. This will be our last official event for the calendar year and its a day of getting together as a group and having some friendly drinks. Some selection of food is available but I suspect a dinner group outing will be on the cards.

I have made a booking for us and will be there at 11am to secure our booking. We will have some table area reserved. I have aimed for approx 40-50 people but may expand it a little. I will speak with the manager again on Saturday morning before everyone arrives to finalise it.

Pub Info: http://www.belgianbeercafemelbourne.com/

Map

map.JPG

:)

;)

Link to comment
Share on other sites

  • Replies 106
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Guest
This topic is now closed to further replies.
 Share




  • Similar Content

  • Latest Posts

    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
    • Id like to race in the US i think alot of those track would suit me   For the s15? Youd be stuck between club sprint and the new Open Am wouldnt you depending on how much interior you have left in
×
×
  • Create New...