Jump to content
SAU Community

Recommended Posts

I am planning to change the gear oil in my R33 GTS-T. I have already purchased the 1 gallon lightweight redline oil.

I have an empty 1 litre VMX80 bottle that has a little hose attach to the cap. Can I use this bottle to fill up my gear box without a pump? (some people mentioned to use a pump to fill it up)

:)

Link to comment
https://www.sau.com.au/forums/topic/13827-change-the-gear-oil-without-a-pump/
Share on other sites

  • 4 months later...

Not sure to tell you the truth. I haven't ever tried it this way.

I managed to get a 1/2 inch torque rench to the filler and drain plug. Gave me heaps of leaverage to get the nuts loose. I still almost spat my guts out my bum cause the nuts were so damn tight though !!!

I 'think' you'd have to take the gearstick surround off, then the 4 bolts around the gearstick. Then that might open up the hole which may let you get a hose down there and put it in the filler hole. Then just use a funnel thingy to fill it up.

Just don't spill the oil inside the car !!

J

I think someone was saying that you can fill it up via the speedo cable plug if you can't get the filler nut out.

Just undo the speedo cable and pull it out, then do it that way.

Not sure if you'd be able to fill it up from inside the car if you use the speedo cable way though...

J

guys, the best way to fill it up is : after u drain it from the bottom plug put that plug back then take the filler -level plug out on side of the b/box and use a pump to fill it up ( i use compressed air to pump it up there ). if u want to get to it from the top this is how the gear stick comes out .

take the trim mould off , gearknob off , boot off , ( u need new cable tie to put back )then there is a c-clip that u have to take off ( u need a long nose to sqeeze it )once u take that off the gear stick just comes out .

warning here though u won't know when its full unless the filler -level pug is out but even then if u fill from there i'm not sure that it will go in to the box on gtrs 4wd 's it won't, it will end up in the trasfer case .

don't bother doing it this way besides u should be able to take the plug out so u can check the level everytime u do a service so u must be able to take the plug out .

u need a long wrentch ( like 300 mm ) with a 1/2 inch drive ( or maybe 3/8 cant remember ) its shouldn't be that tight i never have any trouble undoing it .

Read the link

I did this on two cars on friday, one through a stupid little hole and one through the speedo sender.

USE the speedo sender hole instead of the normal filler hole if u cant get it undone like me :) its a hell of a lot easier, and you get the correct level too.

hmm not the same gearbox, but last week i changed clutch and gbox oil in my other car, damn filler plug was rounded off and so damn tight, the only way i got it off was to take the whole box off and weld a long bar to it to break the seal. total pain in the arse!

as for filling it without a pump, get a length of hose (about 3 meters) that is big enough to fit in the filler plug hole but so its loose. and get a funnel. stick these two together by what ever means neccesary.. silver tape works good to seal it.

put one end in the filler hole and the funnel end above the car (may have to attach it to something unless you feel like holding it there) then through gravity the oil will flow down into the box slowly. if you know how much to put in fine just put that in, but if not just keep topping it up untill it runs out the filler hole and then let it drain till it stops then replace plug

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Cheers Duncan! As always I'm happy to post them here. There's a good 30% more cars at the OAM than what are shown in the photos too, so well worth a visit.
    • Welcome back, glad to hear life's wheel is turning in the right direction
    • Awesome pics Rezz, thanks for sharing them Another stop for my "need to do in Japan" list
    • Hey all, not sure how active SAU is anymore but will ask away anyways. Just wanted to get some experience on the 2008 model GTR CBA model.  I've hit that age in my life (43) where I'm like fk it time to get my dream (midlife crisis) car. Looking at importing one in and seeing if these can be reliable if the main flaws are fixed up. Plan is to keep money aside to do the following straight off the bat to future proof it: * install a stage 1 rebuilt trans with all new bits and pieces.  * install a new Bellhousing from the later model GTRs. Or potentially an upgraded stronger version like MAD or ATR. Besides the above two things and typical maintenance items anything else you'd recommend doing.   Been speaking to a few people and the engine on these are very reliable apparently. But keen on the view of the community here. Hoping to find a nice grade 4.5 with low mileage in Grey. I'd go black but swirls too easy. Look forward to your responses and feedback. Cheers    
    • Do Alan and Keith work on Skylines now? I remember buying stuff from them when I owned my Ralliart Lancer a few moons ago. Definitely genuine guys and be excellent if they dealt with the skyline platform as well.
×
×
  • Create New...