Jump to content
SAU Community

Recommended Posts

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

if u get larger rims you will run a lower profile tyre, and they generally give better feel in the corners due to smaller/harder sidewalls.

however, i have found a better quality narrower tyre will probably offer better grip, unless the difference in width is huge. (this is massively general statement since we arent talking about specific tyres)

depends on if it is for street or strip?

strip you want a wider tyre on the rear, but not a low profile.

street you want a lowish profile tyre. if you go too low profile you get a rougher ride and they tyre won't soak up the bumps. so on rough roads it will skip around a bit more.

wider tyres only help with traction. once you get to a point where you aren't losing traction a wider tyre just adds ressitance.

not a chance.....cheap wide tyres FTL.

Apart from the fact that the tyre compound is what gives the grip, wider tyres will tramline more, aqua plane in the wet.

And don't forget that on the same cars a wide tyre and a narrow tyre have exactly the same amount of rubber on the road.

I've been there I had 265 falken 326s years ago and they were disgraceful

wider tyres will tramline more

damn straight to that..

i got like 8inch fronts, 9inch rears on 17inch. Tramlines a fair bit .. But then again my fronts dont have much thread left, and i got a soft compound rubber( advan rubber :P )

Will get new tyres for the fronts n see if that changes. Most likley it will.

Edited by siddr20
If given x amount of dollars, would it be better spent on quality tyres on stock rims, or upgrade the rims, and get wider tyres to increase contact patch with less quality tyres?

On your criteria, I'd say go with nicer tyres on current rims. Money you spend on buying bigger rims is money you're not spending on tyres.

Take my Z for example (since I only know these prices off the top of my head). I could go to heavy-as-lead 19's with Nankangs or Wanlis or some other dodgy tyre on them from the Temple of Chrome for around $2800...or buy a set of Michelin Pilot Sports in the OEM size.

Michelin Pilot Sports vs Nankang NS2s? Even with the Nankangs being 30mm wider its not a hard choice, if you're talking about grip.

...And don't forget that on the same cars a wide tyre and a narrow tyre have exactly the same amount of rubber on the road...

I dont really understand what you mean? I would think that wider tyres would have more rubber on the road?

I was looking for the best compromise, in a road wheel/tyre combo. I think that the stock r33 wheels are quite heavy (21kg) and not that wide (6.5inch). So was even thinking of moving to a light weight wider rim. Just dont know what is the best package. Money spent on just the tyres and keep the r33 rims, or moving to a light weight rim, wider, but less quality tyres.

R32 gtr rims good compromise?

Edited by lastlineofdefence

Cheaper tyres, offer cheap grip. Cheap grip is SHIT.

I have the same Falkens someone else mentioned earlier. They were on the car when I bought it. Seriously, if I wanted to KILL someone, I would put these tyres on there car.

For lack of grip in a cheap tyre, I can spin 1st+2nd, and not leave a mark on the road, nor any smoke. How's that for a lack of grip?

Put on grippy rubber!

My old commodore ran shit tyres when I got it, I was going to put mags on and run very good rubber, but decided in stead, to save the $2500 on mags, and just buy tyres. $500 later (It's a family car!) and the car behaves totally different. ALOT more grippy.

Just spend your money on the BEST gripping tyres possible (This does NOT mean the most expensive tyre! Read up on the thread above about good tyres)

tramlining isn't just caused by wider tyres. the individual tyre can cause it too. on my 180sx it would pull when you hit bumps. put new tyres on and it stopped doing it.

There are also multiple other reasons for tramlining. Lower profile tyres (not necessarily wider) will also be more prone to tramlining, due to there being less give in the sidewalls. If you don't have your pressures just right (too high or too low) tramlining will be an issue, not to mention incorrect tyre wear & poorer grip levels. Things like camber settings etc will also have an effect.

I was having tramlining issues on the front of my R33 with 225/65 18's & found that if the pressures were much up above 36 I had major problems. I then dropped them to 32 & thought it was better, but it was still there & i started to find the outsides of the tyres were wearing a bit quicker than they should have been due to under inflation & I didn't have as much grip as I would like.

I Now have them at 34 psi & there is virtually no tramlining at all, even on heavily rutted sections of road, & the grip & handing is greatly improved. I'm still to try them a tad higher & lower than this, but this seems to be around the optimum pressure for me.

As far as upgrading the rims is concerned & going for cheaper tyres I'd also say forget it. If you're gonna put something like 265's on the back & can't spend at least $300 a corner on a set of Hankook K104's (The only tyre on the market in that size which seems to be an even blend of cost, performance & durability) then stick with the stockies for now, put good rubber on & start saving for next time.

Check out what people say on the tyre thread too about different tyres.

Edited by JazzaR33
I dont really understand what you mean? I would think that wider tyres would have more rubber on the road?

Not if everything else is kept constant.

The only thing that changes is the shape of the contact patch.

generally with tyres you have

grip, cost, longetivity

pick 2.

17x8 and 16x8 (R32 GTR) are good sizes. 235/45/17 has a massive range of tyres, and they are quite well priced due to the massive popularity. call a tyre shop and find out how much for a set of decent tyres. youll have to research what decent tyres are, and it will depend on your taste and intended purpose. you can pick up 17x8 wheels pretty cheap 2nd hand.

225/50/R16 bridgestone semi slicks are cheap - they are a control tyre for a racing class, was going to put these on the 31. (16x8)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • @soviet_merlin Thanks mate!  Nothing too major but will hold me up for a while. I've got lymphomas to get taken off the back of my neck and the middle of my spine which always conjures scary thoughts!  It sounds worse than it is. Yeah great, conjuring more rabbit hole deepening , just what I need! 🤣  
    • I'd argue the F50 kit I got is very good value. For ~2k I got the calipers (refurbed condition), adapters, pads, brake lines, rotors, and top hats. I think you'd be pretty hard to get Evo/GTR/350z brembos + the additional hardware for similar money. Used market for a pair of front calipers alone I've seen tend to run anywhere from $1500-2000 depending on condition.    That said, something like a GTR or 350z brembo is a lot easier to adapt to the Silvia. 
    • Is there a significant price difference between the Evo/gtr/350z brembos vs the F50? Looks amazing.
    • I was actually being a tightarse at the time LOL... My OCD is tickling me into running a 2nd 8AN Teflon hose all the way down and removing the 2x OEM hardlines. My other side of my brain is telling me to run 2x hardlines front to back (also acts as a fuel cooler, so win win).
    • As I mentioned in an earlier post, I had some trouble with the Silvia's brakes dragging back in 2023. I managed to sort it out then, but the same problem came back to bite me late last year. Just take a look at the picture – I had a feeling the handbrake was acting up again, and I was right. Anyway, I'd been wanting to upgrade to bigger brakes for a while. Not that the Silvia's brakes were bad, but it was more of a "want" than a "need", you know? It was funny, though – at the time, I couldn't find any Evo Brembos, 350Z Brembos, or GTR Brembos for a decent price (of course, tons of them popped up online after I already bought my kit!). I ended up going with an F50 Brembo kit, which came with adapters, brake lines, 330mm rotors, and top hats. The F50 Brembo caliper was used in a few other cars too, like the FPV. I also decided this was the perfect opportunity to ditch the Silvia's ridiculous rear brakes and that awful handbrake (some of you were definitely right about that!). I picked up some R33 calipers and all the necessary bits – rear drums, backing plates, and new hardware to refurbish the calipers. Of course, it wouldn't be a project without a few hiccups. Turns out the brake master cylinder was playing up and basically (to put it simply) keeping the brakes engaged. I had it overhauled, and after some adjustments, everything was working again. The whole process took a while, as you can imagine. To top it off, the front right wheel bearings were shot and needed replacing too. This is a rare occasion where I'm posting an update while it's all still fresh! These pictures were taken just this afternoon.
×
×
  • Create New...