Jump to content
SAU Community

Recommended Posts

my r33 gtst has recently been letting off a really bad fuel smell within the car. after ive been in the car for 15 mins or so i start to get a pretty strong smell of fuel.

i have checked under the car and theres no leaks to be seen so i have nfi what could be causing it? is this a serious problem?

on a side note, does anyone know where u can buy replacement break lights for the r33 S2 spoiler? the break light was loose on my spoiler and its fallen off :\

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/
Share on other sites

I have a similar fuel smell only becomes bad with the sunroof open and windows down? I get good fuel economy and Ive had two mechanics check it out but didn't find anything. If you find the problem post it up, prolly a common issue.

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2590797
Share on other sites

I have a similar fuel smell only becomes bad with the sunroof open and windows down? I get good fuel economy and Ive had two mechanics check it out but didn't find anything. If you find the problem post it up, prolly a common issue.

I started to get a bad fuel smell, but I had really poor fuel economy - was running rich, hopefully it goes away with the next tune.

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2590811
Share on other sites

my r33 gtst has recently been letting off a really bad fuel smell within the car. after ive been in the car for 15 mins or so i start to get a pretty strong smell of fuel.

i have checked under the car and theres no leaks to be seen so i have nfi what could be causing it? is this a serious problem?

I have a similar problem where I get the fuel smell, only when the windows are down though

my fuel cap somtimes works loose, tighten it up and all is good

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2591165
Share on other sites

Is your filter :( plastic or metal construction.

Sometimes this can be a faulty unit.

I have had 2 fuel filter go on me to date...both nissans.

But yeah...you just picked up your car so, get it checked out....You can normally feel with your hand around the hoses to see if there is a leak. You can also smell were it is coming from normally.

Good luck and hope I have been of some help.

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2591942
Share on other sites

Is your filter :( plastic or metal construction.

Sometimes this can be a faulty unit.

I have had 2 fuel filter go on me to date...both nissans.

But yeah...you just picked up your car so, get it checked out....You can normally feel with your hand around the hoses to see if there is a leak. You can also smell were it is coming from normally.

Good luck and hope I have been of some help.

Yeah, i get fuel smell around my filler and in my engine bay. Not noticable in the cabin though....might have to inspect this fuel filter. Where can i locate this in the RB20DET engine bay?

*had my car for ~4 months (purchased complied and serviced)

Cheers,

Steve.

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2592120
Share on other sites

had a similar issue with mine not long ago, mech changed the fuel pump, and the rubber on the inlet hose had a pin hole leak..and was spittin out fuel..

u might wanna pop inside ur boot, open that lid to the right of the battery, get someone to start the car up and jus have a quick look if there fuel spittin out of anywhere there.

hope that helps

cheers

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2592216
Share on other sites

as mentioned, it's often fuel cap, also those temporary ones you get from servo's. You end up having the fuel in the tank splash against the cap when going around corners + fumes = bad smell!

Also if you have changed your fuel pump recently and broke the rubber seal around the pump housing .

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2593190
Share on other sites

try going to supercheap and buying about 3metres of fuel hose and about 6 new small hose clamps

then when the car is cold, look under the hood and find the fuel lines in the bonnet. there should be 3 rubber hoses:

1 - from teh bottom on the engine on drivers side to the fuel filter

2 - from the fuel filter to the fuel rail

3 - coming back from the fuel pressure regulator to the bottom of the engine bay again

i replaced all hoses and clamps, and my fuel smell went away :laugh:

if you are going to do this, i suggest also replacing the fuel filter while you are at it and i even relocated the fuel filter to be within easier reach.

when doing this, remember to remove the fuel pump fuse and crank the car for a few seconds first to get all the fuel out of the lines...

it can't hurt to do it even if there's no problem, as hoses get brittle after 15 or so years of being exposed to 100deg temps!

cheers,

Warren

Link to comment
https://www.sau.com.au/forums/topic/138995-fuel-smell/#findComment-2600964
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • One other thing worth mentioning when I did this job I only jacked up the driver side as I was only doing work there, but from what I understand both wheels should be in the air when removing the sway bar links?
    • Yep it's an r34. Usually people remove struts without removing the front upper control arm (fuca is what i assume this is?) So not sure why mine wouldn't fit. I know on my other car I did a similar job and it wouldn't fit until I removes the ball joint nut even though I didn't remove it prior.   The upper arm doesn't seem to be in the way (the part that's bolted to the chassis. The part that's bolted onto the j arm I'll check that out though.   I was going to compress the spring and put it in with the compressor attached but not sure if it will work  Haven't seen anyone do it.
    • I have a small lip on the boot of the E90 and I've been toying with the idea of trying to mould it in to the boot to remove the gaps. I guess shaving the seams? No idea what the terminology is here.  What I'm wondering is, if it's current double sided taped down, what would I do to more permanently attach it so it makes a good base for the filler? It only has edges so no way to bolt it down unless I add some braces. I've done a lot of fibre glassing in my time so that's nice and easy but I'm not sure what my options are here.  Sorry, this is the best pic I have and I'm 4 million ks from home ATM.  
    • Based on this comment I went googling. A052's in the sizes I want are certainly not cheap, but I couldn't find anything in the V70A anywhere. How much do they run/where do they get sourced from? From what I know (nothing but internet searches and reviews etc) the R888 has pretty much fallen off from anyone's actual use, and the AO52 is the king of "road legal" rubber. Nobody is driving around on their daily for Z221, AO050, DZ03G. At that point, for purely track only tyres - Why not buy actual slicks? Why does nobody actually do that anyway?
    • This an R34? It shouldn't matter though - it should be the same as on any of the others, and by "any of the others" I mean R32, because that is the car that I have had the front end apart on about 50 times this year. Sometimes, it is much easier to get the lower shock eye onto that pin when: a) you have the upper shock nuts backed off a few turns so you can wiggle it a bit more freely. When they are tight the bottom of the strut is much harder to move that _leeeetle_ bit you might need it to to win the fight. b) you have the outer bolt(s) from the FUCA out and so you can move the lower pin around freely too. Then, all you have to do is put the upper arm back on when you've got the rest back together, and this is where jacking under the balljoint can help.
×
×
  • Create New...