Jump to content
SAU Community

Recommended Posts

Will post it tommorrow for you.

Its very basic.

You just need to put the car up on stands at the front, crawl under and find the filler plug first, its on the drivers side side of the gearbox and needs a 1/2 inch socket driver.

loosen off the filler plug (must do first, as if you can't get this off, you can't get oil in.)

get a pan and now undo the drain plug, this plug has a magnet attached to it to attract all loose metal fillings. let the oil drain.

i waited 30 mins and then started the refill process, just clean the drain plug, replace and start filling oil, you know the box has enough oil when it start to exit via the filler hole, I topped it off 3 times to make sure it was exiting oil and not excess on the pump i used to get the oil in the box.

Once your sure its full, replace the filler plug...done.

Link to comment
https://www.sau.com.au/forums/topic/13901-oil-changes/#findComment-284425
Share on other sites

The photos..

ummm, errrr...I think I kind of deleted them...(spewing massive!)

I'm going to take the photos again of the locatios of the plug...I can replcate everything bar the photo of the drain plug.

Again....SPEWING!

Link to comment
https://www.sau.com.au/forums/topic/13901-oil-changes/#findComment-286198
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome Alice......hope you have a bit more luck from here on! What was done in the build?  
    • Hello! I'm new here, I have an R33 GTST that is currently being finished up! Last year was pretty rough, blew two stock turbos so I decided to build the car. Has been down since November, but I get it back next weekend!
    • Hello, I believe my car was imported to America in the 2000s by Kaizo Industries. Would anyone be able to help me find more info on them? I've only found all the basic stuff like that paul walker bnr34, them being shutdown by feds, just stuff like that. Any help would be much appreciated, thanks!
    • I am using Motec M150.  I am not working on the car myself actually.  My workshop is giving all these info, they are quite reputable in the industry and are very familiar with Motec and RBs and have done a few big setups with VCam and single turbo on RBs.  In fact, they built and tuned my engine from day one.  But they are stumped with my engine at the moment and cannot work out how come the compression is so low with the VCam. They told me that they have now swapped in some Kelford cams (without the VCam) and can achieve around 130psi compression and the low end torque is better, but now the engine is doughy as.  It boosts and peaks at more than 1000rpm slower, with twin HKS GTIII RS, it doesn't get full boost until over 5000rpm. I have always thought the VCam was a bit disappointing at the low rpm. To a point I had to ride the clutch a fair bit to get up a small hill from stand still.  That was when I had a clutch.  Now changing to a 8HP, I don't have that luxury and this problem has become a major issue. I am beginning to think the VCam never work since the day it was installed.  Maybe it was just sitting at the most advanced point, that is why it went good at top end but very ordinary at the bottom.  Therefore, with the help of the Holinger 6 speed and paddle shift, as long as it was moving, it drove pretty good.
    • yeah, there's a country that recently started importing Skylines, I blame them.
×
×
  • Create New...