Jump to content
SAU Community

Recommended Posts

This may sound dumb, but i cannot figure out what this button is ment to do?

I was thinking maybe Boot Release? And maybe i have a blown fuse or something?

post-28633-1162806803.jpg

Does it do anything if you hold it down for a few seconds instead of just pressing it?

I had an old maxima before the line with the same remote as that and it set the alarm off if you held it down.

Just tried holding it down, pressing multiple combinations of buttons, but no result. So if anyone has the same key i would love to know what theres does

Also does anyones indicators flash when they unlock and lock there R33. Its just so hard to tell if your a few meters away from the car listening for a clunk when the doors lock

they didn't do anything other than lock/unlock. the unit is a dealer add on and its ALL in the drivers door. with a bit of modding you can make it do the indicators. you need a relay and two 7A diodes to do it.

there is no elec components in the boot for a remote open, so it wont be for that, but i have no idea what it may be for

didnt think they had it factory.

tear the door down and you will see a module inside the rear of the door. that is the remote unit.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This piece is obscenely discontinued. I honestly hate the frameless window design because the rubber gets stressed and the guides as well every time you open and close the door.
    • I wouldn't be concerned at all, other than to suggest having them flow tested when you receive them to confirm they are reasonably similar, and then put the highest to lowest flowing ones in cylinder 6,1,5,2,4,3
    • I’m only posting this cause I thought I had seen a bad review on these somewhere before. Any feedback? Would you guys recommend that if I do buy these I send em to RC to have em checked before installing. Or any other suggestions?   https://www.ebay.com/itm/114009965865?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=JDl-15yLQ8C&sssrc=4429486&ssuid=QTzlFXB1S-S&var=&widget_ver=artemis&media=COPY
    • They see me rollin' they hatin'....... Took me most of the day to make the necessary mods to the mounts to make them fit the car.  Fortunately I was able to just use the mounts that came with the rotisserie. The rear ones are really secure, the front I feel i might reinforce a bit more as it doesn't seem like enough attachment to the vehicle. I'm sure it's fine but better to be safe than (extremely...) sorry.  I drilled and tapped thread into additional M12 holes to each car mount where it attaches to the rotisserie as an extra fail-safe. Without them the side to side movement is just restricted by the allen head pinch bolts, nothing actually goes though the beam. Does now! I still need to adjust the rotisserie to get the car centred in terms of centre of gravity. If it's too high or too low relative to the rotational centre line of the car, it will be like a turtle and roll onto its back or as it currently sits, I dont think I'd be able to rotate it as it sits as it needs to lift the whole car up as it rotates. Ain't happening... I'm going to be nervous as hell the first time I go to spin it on its side...    
×
×
  • Create New...