Jump to content
SAU Community

Recommended Posts

some one please help!!!!!!!!!!!!!!

ive got no power at all......

no ignition lights.

no head lights.

no interior

central locking not even working. ect ect.

the starter motor isnt even clicking.

it seems like a totally flat battery, but i tried jump starting it and still got nothing. checked the conections. checked all the fuses in the boot, in the cabin, and also in the engine bay but all fuses are ok including the main fuse in the boot.

anyone got any ideas????????

Link to comment
https://www.sau.com.au/forums/topic/14228-my-r33-is-dead/
Share on other sites

The other battery i tried is excellent i use it in my other car no probs. ive checked all the fuses including the main fuse.

Gloof i do have an immobiliser, if this is at fault could this stop power to everything though?

Link to comment
https://www.sau.com.au/forums/topic/14228-my-r33-is-dead/#findComment-286913
Share on other sites

i found the problem..............

i must have left the interior light on, the night before it died which ment the battery was totally dead. then in the morning i had nothing tried to jump start it after checking all the fuses and it wouldn't even jump start so i continued asuming the problem was in the car...........

later with the multimeter in my hands i desided to check the jumper leads i was using for continuity. and to my surprise it turns out they where stuffed for some reason they whern't carrying the current??????? they where brand new antizap leads???????

so i tried a different older pair of jumper leads and it started...

end of drama....

Link to comment
https://www.sau.com.au/forums/topic/14228-my-r33-is-dead/#findComment-288111
Share on other sites

cheap jumper leads are worth their weight in packing foam. :D the el cheapo chinese ones have the cable crimped onto the ends through the insulation and generaly are open circuit. either buy decent leads or cut the clamps off, bare back the jumper cables and solder them onto the clamps.

usually even if they do make contact the actual wire is so small theyb wont pass enough current to start a car without glowing red hot and melting all the insulation off them :P

Link to comment
https://www.sau.com.au/forums/topic/14228-my-r33-is-dead/#findComment-288246
Share on other sites

Al

i know i should have just replaced it (now)

but i thought i had a serious prob. any way my mistake.

secoh

the jumperleads i was using where (looked) like very good quality. they are the anti zap ones 400amp from a good spare parts dealer. must have just been a dud set.

Link to comment
https://www.sau.com.au/forums/topic/14228-my-r33-is-dead/#findComment-291420
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 馃槈. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 馃槏.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 馃檹 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 馃槈. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 馃槏 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
  • Create New...