Jump to content
SAU Community

Fs: Cefiro Bits/s13/c33/180 + Dish And Aftermarket Bits

Hella Flush
 Share

Recommended Posts

Hella Flush Experienced

Hella Flush

Posted
Posted (edited)

full 4 stud hubs brakes and stub axle setup front and rear

safety21/cusco 6 point full cage - good for street as it follows all roof and pillar lines

navy blue a31 unregistered/uncomplied 88' cefiro... factory 5 spd manual turbo... fresh 8X,XXXkm engine dropped in - gtr 33 cooler, gtr fuel pump, nismo clutch, eastbear cooler piping etc... many mods can come with it - pm for enquiry/package - has import approval so can be complied easily

fiberglass front and rear fender flares universal - arch type... with rubber seals and stainless hex bolts

random other ceffy shit... series 1 tailights with cefiro written in the middle

kei office front and rear coilovers - height and preload adjustable with front camber tops - need rear tops...

Edited by Hella Flush
NV N01 Experienced

NV N01

Posted
Posted
willing to ship thats no problems aslong as you pay for freight

It might cost a bit to send a whole car up with a cage and coilovers?

Hella Flush Experienced

Hella Flush

Posted
  • Author
Posted

photos can be found here of cage

http://i66.photobucket.com/albums/h252/1at...-10-06_12-1.jpg

http://i66.photobucket.com/albums/h252/1at...22-10-06_12.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Shockabsorber 101

      By GTSBoy · Posted

      KYBs are typically twin tube, putting them in the lower tier of desireability. Do you just want to replace worn out ones for the lowest cost? I mean, you wouldn't just replace one end of a car, if the rears are a similar age to the fronts, then they are probably nowhere near what they should be, and likely won't be great against brand new fronts. So, to spend ~$800 on 2nd tier dampers, when you could get a decent set of MCA coilovers for <$4k.....? As to the strut tops. 1st up, the Sparesbox site specifically tells you that they are not correct for an R33. Beyond that, why do you think you need them?
    • Dose Pipe Sutututu
      High temp brake fluid?

      By Dose Pipe Sutututu · Posted

      That's not very Toyota of the Toyota!
    • benl1981
      Shockabsorber 101

      By benl1981 · Posted

      Bringing an old thread back to life Looking to put some new front shocks in the r33Gtst and the KYB still look ok for a road car. Unless there are any other options aroind that price $200 a shock?  I’d like to replace the strut tops also, is this the correct KYB no. For the strut top, KSM7124?  https://www.sparesbox.com.au/products/kyb-strut-top-mount-ksm7124?srsltid=AfmBOoq-HDru8wSlLnQrhU9gCw_uYdKg8gUQzONY-EQOdnI5iXOWEUjY 341287 appears to be the front KYB shocks part no.  thanks all   
    • MBS206
      High temp brake fluid?

      By MBS206 · Posted

      LandCruiser used to get a fluid flush every 12 to 18 months.   Only because it was about that often the electric motor on the master for brake assist kept dieing and needing to come off.
    • Murray_Calavera
      High temp brake fluid?

      By Murray_Calavera · Posted

      lol I thought I was bad 
×
×
  • Create New...