Jump to content
SAU Community

SOLD

fcruz3r
 Share

Recommended Posts

fcruz3r Experienced

fcruz3r

Posted
Posted (edited)

Quoted from HKSUSA

"The HKS EIDS has been developed to buffer dramatic airflow meter signal fluctuations. By buffering these fluctuations the EIDS prevents engine stalling or stumbling associated with sudden imbalances in air/fuel ratio of airflow meter-equipped vehicles that utilize atmosphere venting blow-off valves."

Item was purchased off ebay, however due to change in plans (i.e: installing safc to correct airflow and not going to install an atmo BOV) this item is now up for grabs. Item was bought off an ebay power seller so I have no doubts that it is in good working condition.

Great for those who want a cheap option of correcting an erratic idle.

Price $70 FIXED - will throw in free delivery via regular mail...however if buyer wants express post..then additional cost to be paid by buyer.

Edited by fcruz3r
Link to comment
https://www.sau.com.au/forums/topic/144117-sold/
Share on other sites
  • 2 weeks later...
  • 1 month later...
  • 3 weeks later...
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GabsReDeal
      New owner of a Skyline R32 GTS

      By GabsReDeal · Posted

      Hello everyone, I am from Malta and have recently bought myself a fully stock 1992 Nissan Skyline GTS. It has the RB20DE engine and thus is NA. Unfortunately, not a lot of information can be found online related to the GTS, unlike the information for GTS-T and GTR variants. Apart of the Skyline, I also got a 1984 Porsche 924 2.0l NA and a 2002 Renault Clio 1.5DCi for everyday use. Excited to be apart of the community and perhaps get better information on cars such as the GTS.
    • MBS206
      Neil's R33 Gts-t Build

      By MBS206 · Posted

      The fuel pump bracket just slides straight up.  Below is a pic I stole off a site. But basically put hand in for fuel pump, wiggle it all about a bit while pulling up. 
    • MBS206
      Neil's R33 Gts-t Build

      By MBS206 · Posted

      Went digging Duncan, there's another "item" that sits down under the plenum that the second pipe from the IACV goes down to. I believe that's the one that is apart of the cold start portion, and it then comes back up under the middle of the factory top plenum. I believe you will find it is unneeded on the forward facing plenum on Cheryl.   I just went digging further for some pics on the location of the one way check valve, and found something that confirms my thoughts from the first half of this point. I feel you can just block off that port that is coming down.     I can also confirm, the other line that you were thinking for vacuum that will just need a one way valve put into Cheryl is 100% correct too. The one way valve is normally screwed into the back of the factory inlet plenum.
    • Fizurg
      R32 GTR o2 sensor front vs rear.

      By Fizurg · Posted

      You’re an absolute legend man. Cheers.  
    • Predator1
      How much roughly to convert stock r32gtr to single high mount turbo + ecu and tune

      By Predator1 · Posted

      The rule of thumb for any GTR thats doing a single turbo conversion is..... seqy... and when i say seqy, i dont mean the pos PPG either. *flamesuit on*
×
×
  • Create New...