Jump to content
SAU Community

Recommended Posts

well after changing my body kit I found some rust on the car.

so I need to take it somewhere to get repaired..

can anyone recomend some places around the hills or richmond/windsor area to get it fixed up..

wasnt sure if its just a smash repair type place that does rust repair as well

cheers.

Sam

Link to comment
https://www.sau.com.au/forums/topic/145883-rust-repair/
Share on other sites

  • 4 weeks later...
its not in guards. its mainly behind the side skirts

I've got it in the exact same spot but i need someone who will fix it in penrith area anyone know anyone and what price i would be looking at .. its not much but if i dont get it fixed it will be in the back of my head all the time.

Link to comment
https://www.sau.com.au/forums/topic/145883-rust-repair/#findComment-2782011
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
    • I was more thinking so it doesn't flop around as much rather than for rotating it. Once you have the balance right, it should rotate well enough, depending on how much resistance there is on the pivot. I think you said the pivot point was on a bearing though didn't you?
×
×
  • Create New...