Jump to content
SAU Community

Recommended Posts

nice you got the z-tune skirts and pods, mind sharing where you got and how much, i plan on doing the same?

and was the fitment good, or did it require modifying?

+1 Please.

Also, would you possibly know how high the skirt is, as i've got aftermarket skirts already and not sure if these would make it too low.

Cheers

+1 Please.

Also, would you possibly know how high the skirt is, as i've got aftermarket skirts already and not sure if these would make it too low.

Cheers

They only fit onto the stock side skirts. So you'll need to remove your aftermarket skirts

also +1 :P

I got them unfitted and unpainted from a private seller over here in Perth because he didn't end up wanting them in the end. I believe he got them from JSAI but last I heard, JSAI isn't doing them anymore.

And in regards to fitment, no modification was needed and they came out extremely well! Although it all comes down to who you get to paint it and fit it for you.

I got them unfitted and unpainted from a private seller over here in Perth because he didn't end up wanting them in the end. I believe he got them from JSAI but last I heard, JSAI isn't doing them anymore.

And in regards to fitment, no modification was needed and they came out extremely well! Although it all comes down to who you get to paint it and fit it for you.

Hey Chris glad to see ur happy with the skirts, its good to see them on! Yeh i got them from Josh (JSAI). I dont know if he's doing anything anymore, i heard a lot of crap about him after i had those sent over. I had no problems at all with him tho.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I didnt present too many conclusions because I wanted your opinions and feedback based on your own experiences. I don't know the exact material, but it is similar to concrete and therfor only has valuable strength in compression. The forces on the set material once the head is removed would mostly be in compression since the grout wants to retain its shape and the block wants to return to its relaxed state since it's still within the elastic region. The grout would theoretically make the block more rigid. The exact amount would take a better setup on my end. Thought experiment: Instead of aliens, twist your favorite fleshlite. Now fill it with grout and allow it to sit for a week. Now try to twist it again. Observe what you see. Now get your other one and blow into it. Observe what you see. Now put it into a can and fill the space between your fleshlite and the can. After it sets blow into it. Less movement in torsion and less expansion i hope.   
    • Hi. Yeah i think that DIS-008 should be ok too but i rather asked. The R8 coils are "sadly" no go for me cuz every solution is for forward plenum. The coils are too tall and one of the(4/5 DK) would not fit under stock J-pipe. And being this NA RB20 i dont even know where to get some forward plenum.(and of course i would need other stuff like custom AFM/ECU etc) and that is kinda non sense for NA without boost. I just looking for solutions for my case 🙂  I try look into those Yaris/Corolla ones.  
    • Damn it, no, I topped up before I got to yours I really should look at Costco locations more when I'm out and about burning through fuel
    • Did you hit the one 5 minutes down the road from my place before heading back south? 😛
    • Costco uses Mobile as a supplier, I always get Costco 98 when I'm near one, they are typically about 30 cents or more cheaper than the local Mobile
×
×
  • Create New...