Jump to content
SAU Community

Recommended Posts

The problem with my Afm required it to be internally repaired (the solder joints on the inside of the plug to the afm's circuit board Under that square black cover) a clean wont do unfortunately.

It would be better for you to swap it with a known good working unit to test.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-300305
Share on other sites

i spoke to dr-drift aka sam and hes on to something, he said that maybe theres a problem with the solinoids that are on the hicas steering,now that would explain why it only does it to the left, maybe theres a short or it robbing power away from the fuel pump??? sound logical

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-300314
Share on other sites

well i unpluged the computer under the parcelself and it still did it,and i think the hicas system is hydraulic. Sooo where do i go from here??? now i know it doesent do it in reverse on when u go forward,and it even does it when you going walking pace to the left, soooo maybe its some sensors somewhere, is there any sensors in the steering rack????? also when u hear backfiring noise that mean rich fuel mixtures cause thats what its doing after the steering wheel goes back to straight, which make me think that maybe its not playing with fuel pump but maybe spark??? does that sound right???

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301226
Share on other sites

Sounds like something to do with the fuel pump..or even something silly like fuel line being twisted or pinched or something as you turn. Check your fuel filter as well, can't hurt to replace.

Backfiring is overly rich yes.. i get it with low-grade fuel sometimes as well.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301267
Share on other sites

The skyline fuel filters are replace type only Z200 I think.

You in your profile state your car is an r31 coupe is this the Rb20 equiped model? if so on the drivers side of the engine bay is all the soildnoids and hydrolic sensors May be you could un plug them an see if the car still plays up also thats the same side as the fuel lines check as someone else stated that the fuel line is not fouling with the steering rack(getteing pinched) . Still dont rule out the Afm until you have swapped it with a known working unit.

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-301784
Share on other sites

well i changed the sparkplugs and its kinda better now,but i found that the 2 plugs that go into the igniter box thing at the back of the engine,when i fiddle around with them then it stops, i tried to do some fixing to the plugs but its a no go,so which makes me now think its the igniter pack thing, does this thing stuff up much???

Link to comment
https://www.sau.com.au/forums/topic/14743-stuttering-probs/#findComment-304315
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi all, I’m currently running a str pipe hi low hks exhaust and downpipe. Was wondering if I change out muffler to a titanium one will it change the sound of the exhaust? Plus I have always liked the look of the titanium pipes … anyone have recommendations to one?    side note already have titanium intake pipes. 
    • I looked up my other car that is a R33 GTST series 1.5. Anyone able to confirm what a Aero Form Bumper is?     (1G) 2 Door Coupe; (2GK + 11V) RB25DET; (4B) 2WD HICAS; (7F) 5 Speed Manual; (14G) Super Fine Hard Coat; (15U) Large Rear Spoiler + Aero Form Bumper + Rear Wiper (Aero Selection)
    • Ha ha, all good! I've almost caved in and realised I'm buying one.  I know myself well enough by now that I will start chasing ADHD butterflies half way through building it and not finish it so I'm better off spending the extra money buying one instead of making one just so I can get into straight away.  I would very much enjoy making one as fabrication is probably a strength and definitely a passion but I don't want that to be at the detriment to the car I'm ultimately building it for! There's some pretty good ones around for ~$1100 at the moment so I think I'll just go that way.  At the end I sell it or as mentioned, get another project to make further use of it! Thanks gents.  
    • That link was very helpful thank you.
    • That is the option code, not the VIN. Regardless all of that production is considered series 2: https://gtr-registry.com/en-ecr33-vin-table.php
×
×
  • Create New...