R34 Gtt Brakes Onto S2 Stagea

[chook]

Im looking to upgrade my S2 Stagea brakes (2 pot 290mm/ 1 pot 292mm) to R34 Gtt brakes (4 pot 310mm/ 2 pot 297mm) , rotors and calipers, front and back. Does anyone have any tips or advice, also, would i need to worry about the brake bias with such a change ? cheers

[Russman]

Hey Chook

I've just upgraded to R34 Gtt brakes on the front of my r32. check out this thread. It may help. http://www.skylinesaustralia.com/forums/in...howtopic=139091

I noticed your car is a 2000 model so I am guessing that the bolts and everything will be the same as the R34. That was the only modification I had to do besides cutting away the shroud to fit the bigger disk.

Good luck.

[chook]

my only concern is the whether i would need an adaptor plate for the caliper bolts, hopefully the holes are in a standard position, thanks

[Russman]

I don't think you'll need adapter plates.

Best way to check if they will fit is measure the distance between the centre of the 2 caliper mounting holes. If it's 100mm they should fit no problem.

[thedriver]

my only concern is the whether i would need an adaptor plate for the caliper bolts, hopefully the holes are in a standard position, thanks

Hey Chook,

Did you do this brake upgrade?

Where there any requirements for adapters?

Any other issues?

What did it cost you?

Big benefit in performance?

I need to replace my rotos and pads and am looking at similar upgrade.

Cheers,

Tee