R32 Actuator In R33

[cheez]

hey guys

been doing some research into the best way to boost the r33 s1 RB. check out the link:

http://nissanskyline.6te.net/tuning_GTS25T.htm

it has a section on boost. it says that with the r32 skline having the same boost actuator as the r33, its a simple swap and you increase your boost without any other mod. it mentions that the ony diff between the 2 actuators is the spring pressure (5psi-r33 and 10psi-r32), but is this really a healthy mod for the car?

is it gonna last as long as say putting in a proper bleed valve and manually adjusting to get desired 10psi on the standard turbo?

input would be good?

cheers

[mad082]

it will perform better than a bleeder as there is no air being let out of the system, and should hold boost better.

[xRHETTx]

People do this all the time.

[cheez]

just 1 more thing, will i need to change anything in regards to the comp or stuff like that??

do i just get a r32 act and slap it in and ill run the 10psi?

it says about diconnecting the 2stage boost controller? does that mean the standard boost controller?

if so which way do i then connect the hoses or just block em or wat?

Edited December 26, 2006 by cheez

[mad082]

to disconnect the 2 stage, just remove the T piece and run a single hose from the intercooler piping to the actuator.

[cheez]

cheers guys. appreciate the help.

daniel