Jump to content
SAU Community

Recommended Posts

WEll i can agree with the comments above. (well some of them). Anyway i vought my car for $7000 its an r33 4door series 1. It was chaep enough. I bought it in melb and it cost me about ......... ($7k +rego+RACT inspection) that was it.... along with the obligatory spirit of tas fee. (cant get around that unless you buy your own boat) . I would just like to agree with the comment that you get what you pay for.

I will be the first to admit that even though my car checked out ok on first inspeciton it was still a bit of a lemon.

Coz i had some plans it didnt matter so much, however none the less its still a pain in the AR$E. I had a turbo with shaft play/exhaust manifold with 8 out of 12 botls snapped/ buggered o2 sensor/ buggered airflow meter/ and some fueling issues/ oh and my suspension was FU#@ED. i knew this before i bought the car and knew that i was going to change it anyway so it wasnt a big drama.

Now after about about hhhhmmmmm $5k+ i have highflowed turbo/manifolr/02/airflow/suspension/exhaust and some other bitz and peices fixed. adding onto that the rego and insurance (shannons I highly recomend) i am at a total of about $15k. Now i want to get a tune or aftermarket ecu or something. Anyway that is not what this topic is about.

So my point really (or should i say finally) is that you DO get what you pay for and i also think that... whatever you buy, be it a car from melm or tassie, get it mechanically chekced or at least take it for about a 20-30km test drive so that you can really get a feel for the car..

:wave:

Thats my 20cents worht (probably more like $5 worht but who cares)

Hope you find something u like :P

  • Replies 65
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

WEll i can agree with the comments above. (well some of them). Anyway i vought my car for $7000 its an r33 4door series 1. It was chaep enough. I bought it in melb and it cost me about ......... ($7k +rego+RACT inspection) that was it.... along with the obligatory spirit of tas fee. (cant get around that unless you buy your own boat) . I would just like to agree with the comment that you get what you pay for.

I will be the first to admit that even though my car checked out ok on first inspeciton it was still a bit of a lemon.

Coz i had some plans it didnt matter so much, however none the less its still a pain in the AR$E. I had a turbo with shaft play/exhaust manifold with 8 out of 12 botls snapped/ buggered o2 sensor/ buggered airflow meter/ and some fueling issues/ oh and my suspension was FU#@ED. i knew this before i bought the car and knew that i was going to change it anyway so it wasnt a big drama.

Now after about about hhhhmmmmm $5k+ i have highflowed turbo/manifolr/02/airflow/suspension/exhaust and some other bitz and peices fixed. adding onto that the rego and insurance (shannons I highly recomend) i am at a total of about $15k. Now i want to get a tune or aftermarket ecu or something. Anyway that is not what this topic is about.

So my point really (or should i say finally) is that you DO get what you pay for and i also think that... whatever you buy, be it a car from melm or tassie, get it mechanically chekced or at least take it for about a 20-30km test drive so that you can really get a feel for the car..

:wave:

Thats my 20cents worht (probably more like $5 worht but who cares)

Hope you find something u like :P

With buying from melbourne, how much does registering the vehicle cost when it comes into the state. I had a look on the DIER website yesterday, and could only come up with a total cost of around $600-$700, is this totally wrong.

Also, what are people paying for fully comp insurance? I planned on going with shannons, and am over 25 with a rating 1...unfortunately their online quoting thingy is terrible.

I'm still not totally convinced in settling for an R32 either...the 33's are a lot more refined in the styling dep't + the advantage of having a 'newer' car.

There are a few examples in Vic that seem to be worth a look, and if the only added cost is the trip back on the spirit (bugger all), inspection costs and rego (hopefully not too much), it might be the more viable option.

On top of the actual registration you have stamp duty, I cant remember how much it is, something like 10%?

If the car is not already registered on the mainland, you can get a non registered permit from service tas for like $40. This allows you to drive your car from where it is, to where ever in Tas, to get inspected and then registered.

Without this unregistered permit, you are unable to get your car insured until it is registered.

Ive heard of some guy who had bought an R34, didn't do this, was going to get insurance the next day and had an accident, car was a write off...

Insurance, I'm with Just Car, and pay nearly $900. I'm under 25, so it could be less for you.

Just Car have a really good insurance quoting system on their website, so check it out.

Well, with reagard to the rego, i payed about... 600-700 (something like that) and the stamp duty was on top of that. (cant remember exactly). With the insurance it depends a lot on what you want the car valued at. Mine is valued at $12k-$13k through shannons and i pay (full comp) $800 something (low eight hundereds) they are really good on the phone. Most of the people are interested in cars, that work there. One thing is, that if the car has not been registered for more than 3 months you will have to supply them with photos of the car from all 4 corners and engine bay and inside front, back and boot. So that they are happy that the car isnt crashed before yiou insure it.

Hope that this helps some. If you have any specific questions feel free to give me a pm

>_<

Thanks for your info guys...it all helps!

I've just recived a quote for fully comp from Just Cars. Now, it says in bold writing at the top of the page $740...however when you look down the page at the excesses it says $400 for stadard? and plus vehicle is $1000. Does that mean my total annual insurance is $2140 based on a value of $14k...thats more than 10% of the agreed value, thats just insane!

No the excesses are what you have to pay if you have an accident or your car gets stolen, before they fix it.

If your car is a write off in any event, they will deduct this amount from the total you get back.

Edited by Az_StrYdeR

"The initial payment should be around $8,900 for the FOB price, plus $1,000 for our service fee - other payments would not be due until after the vehicle arrives in Australia."

"http://www.j-spec.com.au/list/9051"

I think you're on drugs!

lol

It's not canada.

http://www.j-specimports.ca/pics/9051/

her u go

but yeah i think i'm on drugs

Its under negotiation from there other yard i would say. It links to the CA site because thats where the pics are.

Reason for price being cheap is that 4wd has been disabled (i would say front drive shaft removed) and its missing a GTR badge :)

i see the one here in deloraine a fair bit. I work out there. it gets a fair caining. I think that it goes alright, i have only spoken to the owner once, i was pretty pissed and cant remember much, but yeah, if that is what you are after, check it out. I think it lives on West Godderick street in deloraine. (i think that is how u spell the street name.

I would ask about service history though coz i have seen it sideways a couple of times :)

Again i will say to make sure that you do your "homework"if going through an importer.

There are some very reputable ones out there but there are also the "dodgy" ones that wont blink twice with taking your hard earned cash and screwing you over :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi soviet_merlin, We appreciate your concern regarding this possibly being some sort of PR/Political hype, I assure you that is not the case, I wish we could claim something like that, but in this case, we merely reached out for comment on the basis of the outrage we too felt, as those heavily in the automotive industry. Ps. the original source in the social media post is CarExpert not CarExplore.    Best, CE.
    • Made a bit of a discovery, but while I was cruising, I randomly decided to test to see if it worked and it showed up on my IC7. The entire time I tested it before, I never thought to turn the ignition on. I only tested it with head lights turned on but with the ignition off. Huge oversight on my end. I’m a dummy. I know. 
    • G'day all, I have drilled and tapped the hole for the relocation of the timing belt tensioner. That was straight forward. I'm unsure if I need to also put another hole for the smaller stud that the spring behind the tensioner catches on (this is how it seems to work in its original spot). Or do you not use the spring behind it and just torque it down? Thanks in advance, I did a search but couldn't find anything related and it doesn't mention it in the rb30det sau guide.
    • Hi All,  just thought I would provide an update as I know smooth (Matt) was on this forum from 2003.    my brother Matthew passed away end of may 2024 at the age of 41 from liver failure. I am not sure how many of his original team krazy friends are still on here or active but thought it reasonable to let the forum know.    if you have any photos or pictures it would be great if you could share them.    it took me a while to work out he was active on here.    thanks so much 
    • Hi All,  just thought I would provide an update as I know smooth (Matt) was on this forum from 2003.    my brother Matthew passed away end of may 2024 at the age of 41 from liver failure. I am not sure how many of his original team krazy friends are still on here or active but thought it reasonable to let the forum know.    if you have any photos or pictures it would be great if you could share them.    it took me a while to work out he was active on here.    thanks so much   
×
×
  • Create New...