Jump to content
SAU Community

Recommended Posts

Hi there SAU members my 32 has developed an annoying missfire dosent happen all the time just every now and then but what a pain in the arse started again today ,so far ive had the coils checked and they seem fine ,no backfiring at all ,it mainly happens when you back off after driving at about 3000rpm and slow down just to cruise (i know 3000rpm is just cruising but just putting by if you know what i mean)anyway i was told it could be dirty injectors but so i put two lots of injector cleaner through it in the last 2 tanks to no avail,could it be the fuel pump or fuel filter im at a loss atm,send me you thoughts on what it could be please i'll try anything that wont cost anything to much LOL, thanks guys

  DREW32 said:
Hi there SAU members my 32 has developed an annoying missfire dosent happen all the time just every now and then but what a pain in the arse started again today ,so far ive had the coils checked and they seem fine ,no backfiring at all ,it mainly happens when you back off after driving at about 3000rpm and slow down just to cruise (i know 3000rpm is just cruising but just putting by if you know what i mean)anyway i was told it could be dirty injectors but so i put two lots of injector cleaner through it in the last 2 tanks to no avail,could it be the fuel pump or fuel filter im at a loss atm,send me you thoughts on what it could be please i'll try anything that wont cost anything to much LOL, thanks guys

get some new plugs and gap them to about .7mm

should do the trick...

ps, dont buy iridiums just get standards from repco or similar

I had similar issues, infact - still freakin do!

car was spluttering and extremely laggy on gear changes, had 7 runs at WSID and all did 14.7

got plugs changed, car felt so much stronger, no spluttrering or anything on gear changes or when backing off.

but now, car is running like shit again, a few ppl think maybe my car is running a bit too rich and fowling the plugs causing it.

so im not happy yet again.

I'm currently getting my R32 GTR's ECU chipped and retuned because it was running far too rich. It had a mine's ECU in it and it probably was in it when it was shipped over from japan. The spark plugs started to foul up after I drive it for some time. Especially once the engine becomes warm the stuttering and misfiring became worse. When I drove it to the mechanic it got to the point where I really didn't want to push it above 3 grand cause it was spluttering and misfiring like mad. I figure due to auto choke it doesn't misfire when it's cold. I think replacing the spark plugs is a short term fix and the best thing to do to get peace of mind is take it to a decent mechanic who can suss these things out. I first took it to a mechanic who spent alot of time looking at AFM's, intercooler piping etc. He was adamant it was one of the AFM's but he didn't even check the coil packs and spark plugs.

oh and also my cat converter was clogged due to all the unburnt fuel causing the engine to not run optimally as it was forcing against all the built up crud.

Either way, it could be any of the things I've listed above or a combination. Either way it'll just frustrate you as it did me, until you grab your shovel :) for you money pit and take it into a mechanic..... unless you can retune an ECU by yourself! If you can let me know! :P

good luck ;)

Edited by Burgerman
  Burgerman said:
I'm currently getting my R32 GTR's ECU chipped and retuned because it was running far too rich. It had a mine's ECU in it and it probably was in it when it was shipped over from japan. The spark plugs started to foul up after I drive it for some time. Especially once the engine becomes warm the stuttering and misfiring became worse. When I drove it to the mechanic it got to the point where I really didn't want to push it above 3 grand cause it was spluttering and misfiring like mad. I figure due to auto choke it doesn't misfire when it's cold. I think replacing the spark plugs is a short term fix and the best thing to do to get peace of mind is take it to a decent mechanic who can suss these things out. I first took it to a mechanic who spent alot of time looking at AFM's, intercooler piping etc. He was adamant it was one of the AFM's but he didn't even check the coil packs and spark plugs.

oh and also my cat converter was clogged due to all the unburnt fuel causing the engine to not run optimally as it was forcing against all the built up crud.

Either way, it could be any of the things I've listed above or a combination. Either way it'll just frustrate you as it did me, until you grab your shovel :) for you money pit and take it into a mechanic..... unless you can retune an ECU by yourself! If you can let me know! :P

good luck ;)

yeah i think your right i do need a bit of luck LOL ,my brother in law is a very good mechanic and told me when it first started to happen that it couldnt be the injectors its more than likely a engine managment system problem and after hearing a few of the problems you other guys stated think i'll change the plugs today just to see what happens , would like to get it put on a dyno for a proper tune but there isnt one around here for at least 100k's so thats a bit of a problem but anyway lets see what happens with those plugs!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • bro, knowing the Japanese in  the 90's, i wouldn't be surprised if they shared components across their model lineup.
    • Maaaan so many "little" things  i rly hope my old RB20 would be "ok" and not too bad. I try to learn what and what not do i need. I look at crossmember at it looks different...even parts numbers are different. Wiring and all that i rly do not know...yeah someone mentioned the speedo thing. On that yoke clip. I rly do not know what can and cant be done "custom" so that is why iam asking to know and not be suprised 馃檪  I know what it looks like  
    • Oh, there's also the gearbox crossmember which will probably be different between the small box and the big box, and the wiring loom will probably need to be modified, because the plugs for the switches etc, will probably be different. And I think the speedo on the small box R34s is from somwhere stupid, like the diff, possibly, so you'd need to work out what needs to be done about that (assuming it is different). I think the thing you need to realise is that the front end of that yoke is a large hollow tube with splines on the inside that mates with the splines on the box's output shaft. It is a dedicated thing - not available "aftermarket". They were made to suit that box, by the car's OEM.
    • You need to buy a Saab Matt, ours had a button that turned all the dash lights off. Any decent aftermarket dash has sufficient brightness control and a headlight input for day/night settings. None of which probably helps OP
    • Yeah thanks...i thought it would be alot more i dont know 馃槃 I saw some videos on converting push/pull and it seems you need to "drill" the hole for slave(master) cylinder and buy some converter kit. On that front yoke clip i did not even know that is a thing and i need to source that(custom shops do not do that?) But anyway thank you for the info
  • Create New...