Jump to content
SAU Community

Recommended Posts

Hmmm, difference between the GTS and the GTR...

Think about the biggest difference possible, that is what it was like! :lol:

The GTS felt like it took years to get to 100, in the GTR you put your foot down in 1st, change to 2nd and what do you know 100!!!

It's such a big difference, it's hard to explain but it's major...

Link to comment
https://www.sau.com.au/forums/topic/15-god-damn/page/4/#findComment-314
Share on other sites

Prank,

The same thing happened 2 me a few months ago. The rear bumper and exhaust were F***ed, but it didnt look so bad

Turns out the wole exhaust needed replacing, the rear diff and HICAS were serviced, and new rear bar. about $5000 woth of damage which their insurance covered. I almost didnt get their details because the damage didnt look so bad and they offered to pay me $800 cash for damages.

The point is there is more than meets the eye. Make sure the repairer checks everything.

If Ur girlfriend still feels bad about the accident, take her shoe shopping. That'll cheer her up :P

Link to comment
https://www.sau.com.au/forums/topic/15-god-damn/page/4/#findComment-323
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Here is the before and after of the scraping/sanding of the IC pads on the tachometer board for the fix mentioned in this thread. And yes it worked fine after. Just a note if you change any components on the board the tach calibration can be wrong showing the wrong idle etc...only problem is once it is installed back in the cluster you can't get to it to adjust...ouch! My fix was to cut out the calibration pot (the blue one) from the board and run it with two wires to the fuse panel under the dash where I could adjust the idle calibration once everything was installed. And yes I soldered everything up again including the half soldered components either side of the IC in my photos                                
    • After an excellent condition, working! oem radio for a 97 r33 And the steering wheel shroud/cover as mines a little bit scratched up Am in Melbourne
    • So my exhaust is loud and sounds awesome (good thing) but also is very loud when coming and going, dont want to piss off the neighours etc Are the varex adjustable mufflers any good? I contacted them but they dont make r33 specific exhausts Ive also see the adjustable inlets on this site but apparently they might restrict airflow too much which wouldnt be good for the engine. Would prefer something thats adjustable from in cabin so i can change it on the fly, dont really want to put in one of those permanent exhaust tip things.  Any other recommendations would be appreciated!
    • You don't need to lean as far to pour the oil in, or change the spark plugs either 😛
    • Indeed, it is much easier to get at the filter with the engine on a stand
×
×
  • Create New...