Ford Xf Throttle Body And Powerfc

[pavel]

PM sent cheers

[RB20/30Det_VL]

mate u need to make a bracket its easy, get a 3-4mm thick piece of metal about 20mm wide and about 120mm long measure the distance and mark the holes where needed, use a 5 or 6mm drill bit for the mounting holes and a 14mm drill bit for the centre hole then bolt it on and measure the resistance at open and closed and adjust, connect it up and check voltage at open and closed.

those measurements are off the top of my head dont quote em

drill bits are right

[StockyMcStock]

agreed, do that ^^^

just check to see which way it all opens etc, you'll figure it out. the TPS has an arrow on it showing closed to open direction. it is the same as the XF throttle body, but opposite to the RB25 one.

if the shaft does not fit inside the TPS, you need to file a flat section in it until it fits snugly on. i've heard that some XF shafts need this to be done.

[pavel]

Plugged in standard XF TPS and PowerFC seemed to calibrate itself. Reads about 0.3V on IDLE and close to 5.0V on WOT

[SirRacer]

pavel did you end up putting up pics after this marathon effort?

cheers