Jump to content
SAU Community

Recommended Posts

My r33 gtst has a slight backfire when i back off the gas followed by a gargle, all coming from the exhaust. I have only had the car a week and it has always done it since then but i have put some injector cleaner in the fuel and it seems to now be worse. Is this normal for a skyline to be doing this?

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/
Share on other sites

I haven't seen a Skyline that doesn't do it :D

Edit: Oh, if it blows lots of black smoke, this too is normal and nothing to worry about. I met someone who drives a turbo Audi and he thought that all Skyline engines were in sh*thouse condition because of all the smoke he sees them blow, I had to educate him that it was just unburnt fuel because of running hella rich.

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-313371
Share on other sites

Hehe, speaking of scaring pedestrians, I once scared the shite out of some bogun fat chick in my old XY Falcon with worked 302 Windsor and no mufflers. A bunch of boguns decided to meander across the carpark in front of me doing 5kph. It wasn't a pedestrian crossing, so I got a bit pissed off especially since they were in single file and walking slowly.

When the last one (fat chick) was right in the middle of my car, I floored the accelerator and slipped the clutch a little to inch forwards about 5 cm. She just about shit her pants :O

Don't think I can get the same effect happening again with the 'line :P Well, maybe if I moved forwards 1 metre instead of 5cm :P

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-313626
Share on other sites

  • 5 weeks later...

I drive a Turbo Audi - but im not that guy :P

'line engines are pretty awesome actually, i almost got one, but they got too common.

I know of one Audi A4 Turbo Quattro that blow a lot of smoke - but he has over 220kw at all four. So its a bit extreme. PS. watch out for him. :P

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-361693
Share on other sites

Does it sound angry? Yes? Then good! Mine consistanly backfires in 1st, 2nd and 3rd gear changes and often if i back off from higher up in the rev rang,Lovin it. The rumble under compression is a nice sound also. It can be controlled with longer slower gear shifts.I must admit a good Ffowing exhaust and rich fuel mixture increases this, and no cat! Oh did I say no cat? Thats illegal isn't it?? LOL

You don't want to much though as that can be cop bait...

RJB.

Link to comment
https://www.sau.com.au/forums/topic/15218-backfiring/#findComment-361879
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hey y'all! I'm curious about how y'all go about widebodying your cars. I noticed that when running a square setup, my front wheels are a bit more tucked in than my rear wheels. Not by much, maybe 5-10mm. This leads me to wonder - when I widebody, should I use narrower front flares and wider rear flares? I found a set of 40mm rear flares that I really like, and was thinking of pairing them with some 18mm front flares, but I don't want the car to look strange. How have others done this? Note, I'm in a sedan. Thanks!
    • And if it was anything other than an auto tranny part, it might be a problem. But seeing as all auto trannies belong in the recycling bin, it's fine.
    • I have an R32 Fenix rad. It is good.
    • All the schemas I can see, indicate your typical setup of ATF 'cooler' (read: heat exchanger) in the bottom radiator tank..ie; https://nissan.epc-data.com/stagea/wgnc34/5413-rb25det/engine/214/ ...but I can prattle on a bit here. These trannies have a thermistor in the sump ~ the TCU reads this and 1. bumps the line pressure up when the ATF is 'cold' and 2. prevents the TC lockup clutch from operating, until the ATF comes up to minimum operating temp (keeps the ATF 'churning' through the TC so it heats up quicker) -- trigger point is around 55C. In these conditions, the engine coolant temperature rises faster than the ATF temperature, and also helps heat the ATF up, which is why it's best to think of the in radiator tank setup as a heat exchanger ; the heat can flow in both directions... ...with these trannies, the 'hot' ATF comes out the front banjo bolt, flows through the cooler/heat exchanger, and returns to the box  via the rear banjo bolt. This gets a mention, due to the wildly different opinions wrt running auto trans fluid coolers ~ do you bypass the in radiator tank altogether, or put the cooler inline with the in radiator tank system...and then, do you put the additional cooler before of after the in radiator tank system?... ....fact is the nominal engine operating temp (roughly 75C), happens to be the ideal temperature for the ATF used in these trannies as well (no surprises there), so for the in radiator tank system to actually 'cool' the ATF, the ATF temp has to be hotter than that...lets say 100C -- you've got 25C of 'excess' heat, (slowly) pumping into the 75C coolant. This part of the equation changes drastically, when you've got 100C ATF flowing through an air cooled radiator ; you can move a lot more excess heat, faster ~ it is possible to cool the ATF 'too much' as it were...(climate matters a lot)... ...in an 'ideal' setup, what you're really trying to control here, is flash heating of the ATF, primarily produced by the TC interface. In a perfect world, wrt auto trans oil cooling, you want a dedicated trans cooler with builtin thermostatic valving - they exist. These should be run inline and before the in radiator tank system ~ when 'cold' the valving bypasses the fin stack, allowing the ATF to flow direct to the in radiator tank heat exchanger, so it works 'as intended' with helping heat the ATF up. When 'hot' (iirc it was 50C threshold), the valving shuts forcing the ATF through the cooler fin stack, and onto the in radiator tank heat exchanger...and you sort of think of it as a 'thermal conditioner' of sorts...ie; if you did cool your ATF down to 65C, the coolant will add a little heat, otherwise it works as intended... ...the 'hot' ATF coming from the front bango bolt, is instantiated from the TC when in use, so all/any flash heated oil, flows to the fluid-to-air cooler first, and because of the greater heat differential, you can get rid of this heat fast. Just how big (BTU/h) this cooler needs to be to effectively dissipate this TC flash heat, is the charm...too many variables to discuss here, but I just wanted to point out the nitty-gritty of automatic trans fluid coolers ~ they're a different beastie to what most ppl think of when considering an 'oil cooler'... /3.5cents   
    • Been a busy but productive day. Axle and hubs acquired. All fitted up after a bit of modifying. Need to sort out wider mudguards and running light reflector covers but other than that the trailer is gooood to go !!
×
×
  • Create New...