Jump to content
SAU Community

Recommended Posts

Hi All,

From now till 31st March 2007, JS Auto Imports is offering full kits for your Skyline, Silvia, 180sx, S15... etc

This group buy will allow everyone to get a discounted rate on these kits due to bulk order...... $750 per kit just let the guys from JSAI what your after VERTEX, VEILSIDE, BOMEX, ETC....

Please PM me with interest or contact Josh from JSAI on 0405153290

Link to comment
https://www.sau.com.au/forums/topic/154767-flexiglass-body-kits/
Share on other sites

Ok for sprayed and fitted its $1750 i know this is pricy but JSAI do the trial fit unlike other places say the kit is moulded to ur vehicle not just a standard kit for everyone......

Yeah they do any part you need front, rear, side skirts.

Also kits can be found at :

http://www.jsai.com.au/shop/index.php?cPat...c335cdcf2575765

THey can preety much copy any kit for u

flexi? umm those stuff that can bend and twist?

and these offers available olnly in sidaney?

The kits bend in 180 degrees.... not to sydney we can post....

Edited by RYD11R
hay I was wondering how much a Bomex kit would cost for a 32 4 door or if you can get them at all?

Thanks

I think it would be the same price.....

Best thing is to contact JSAI give Josh a call on 0405153290

  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Latest round of updates on the car. I purchased and installed a SWS clutch slipper to help with 60ft times and got some second-hand good condition 275/40R17 Hoosier DR2 radials. Test and tune in November showed the tyres were an upgrade over my over 15 year old mickey Thompson's and I got a 1.8 second 60ft and pb et of 11.71 but even then, that run wasn't great due to rain and driver error (the event got called off 10 minutes later fast forward to the weekend just gone 25th of Jan and there was finally a break in the weather to let racing happen. The first run the track was slippery and only managed a 12.1@129 Second run the track was better and got a new pb et and mph: 11.54@131   Lith and I then worked out that I installed the previously mentioned clutch slipper incorrectly and its never been working, and I had just been dumping the clutch the entire time, we also noticed it was on street boost and not race boost. So I lined up for a third run with the car turned up in the first two gears, but the passengers side axle objected to clutch dumps and left the chat which stopped my weekend.   so there will be another attempt in the future once I replace the tyres as they rubbed and are stuffed now. but a low 11 should be on the cards.
    • Ceramic coating and heat shielding, you mean?
    • Turbos don't require pulling the motor apart so that's "easier". I would recommend the Nismo R3 turbos instead if you want to do stock twin turbo. It doesn't make as much power as the 2530s but it's only like ~50 whp off the mark and should have better response (ball bearing CHRA, slightly smaller turbo). A local that went with a Garrett G30 and 6boost manifold recently nearly burned his car to the ground after the hood insulator started melting and and burning so if you go single turbo I recommend doing a lot of research and validation work to make sure you don't do the same.
    • New rear lights, filler panel sprayed, cleaned and back together    before, during, after shots 😍
    • 100% is gyprock, I agree. Slip of the keyboard. Haha! I left my indicator bulbs out to save a bit of weight.
×
×
  • Create New...