Fmic Install In Stagea

[mike40sydney]

i fitted up my fmic and when i remover the stock pipework there was a small hose that comes from what looks like a solonoid on a compressor and conected to the pipe that feeds the plenum it had a smaller pipe pressed into it to which the rubber hose im refering to was atatched.the new pipe fittings do not have provision for this .....where do i connect it now? any ideas guys????? Edited February 10, 2007 by mike40sydney

[mike40sydney]

come on guys one of you must know

[mike40sydney]

gee guys i was sure one of you gurus whould know what im talking about

[Adriano]

Screw a fitting into the piping

[mike40sydney]

forgive for being new to all this but what exactly does the small pipe do

[Adriano]

feeds boost to the wastegate actuator to control boost, without it it will overboost and blow the turbo.

[mike40sydney]

feeds boost to the wastegate actuator to control boost, without it it will overboost and blow the turbo.

thanks heaps is there another fitting anywhere else i can connect it to

[wolverine]

mike, the hose you showed me doesn't go to the wastegate. one of the hoses off the T goes to the wastegate.

[megaclarky]

That pipe goes to the pwr steering pump.... did you find an alternative point to plumb it in????