Jump to content
SAU Community

Recommended Posts

Noticed the other day something had eatin the paint on the side of my front bar. Popped the bonnet and there was fresh battery acid everywhere, all over the battery, all over my intercooler pipe and various other places. It had leaked down the side where my wiper water was and then out onto the front bar! Not happy Jan! To make things worse i had only just got my car back from a simple, run of the mill car service. Now i dont know if it's just coincedentle that maybe the battery had a sh#@ fit, or if maybe they overfilled the battery or something when they serviced her??? What are your thoughts cause i am a bit of an unhappy camper at the moment

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/
Share on other sites

Might be worth checking that your alternator is not overcharging the battery which can happen. This can cause the acid to overflow as you said.

Unless they service guys over filled it?

Dont forget it seems harmless but give it some time and you will have bad corrosion everywhere, so wash it off pretty thoroughly.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909111
Share on other sites

Was the filler caps still screwed on tight on the battery?

Chances are they filled it to the brim (which is a no no) so once the battery starts to 'gas' and heat up during charging, it would have spewed the electrolyte everywhere as you would know. OR your charging system voltage is out of spec causing it to gas violently.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909112
Share on other sites

Ahh not good.

I had a new Exide battery do this to me some time ago.

The auto store replaced it as goodwill, they believed my car was overcharging or the battery had been dropped.

I know I definitely didn't drop it as I put it in the car at the autostore the second I bought it.

The PFC has near perfect volts also. So its not overcharging.

This new Exide is good but. The old would loose its charge by simply leaving on the radio while I washed the car, and it was a new battery. :S

It stuffed a lot of the engine bays paint directly below the battery, a metal brush, rust kill primer and paint and its all good.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909221
Share on other sites

What do you guys think i should do? Are the mechanics at fault, looks like it was topped right up and the caps were very tight to! Should i be getting them to fix it? I haven't really touched it since it happened (last thursday). Do you think a steam clean will be enough? the damage has been done though, my intercooler piping is screwed, the paint in the engine bay is the same and my front bar has an annoying patch on it with no paint. Very noticeable when my paint job is well looked after!

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909255
Share on other sites

It might be worth talking to your insurance company. If they believe the mechanic was responsible they will be better able to follow it up than you, and because the other party can be identified you shouldnt have to pay an excess or lose your rating.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909315
Share on other sites

without telling them the problem, ask them what they've done for this service "just out of interest" because "the car is running great"...u lie of course

that way they dont know the damage and try to deny touching ur battery

Edited by andz69
Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909317
Share on other sites

without telling them the problem, ask them what they've done for this service "just out of interest" because "the car is running great"...u lie of course

that way they dont know the damage and try to deny touching ur battery

Do this first to see if you have a leg to stand on......

It might be worth talking to your insurance company. If they believe the mechanic was responsible they will be better able to follow it up than you, and because the other party can be identified you shouldnt have to pay an excess or lose your rating.

And once you have found out about the other and it's worth continuing then procced with this!

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909809
Share on other sites

I agree with ^^^... but if you get your insurance company involved you have to pay your excess cos your making some what of a claim... i dunno about you buy my excess is like $1500 lol

As andz69 said be sneaky with em cos theres more than 1 way to skin a cat... But if you can prove they caused that damage then you can threaten to take em to something like the tribunal if they tell you to take a walk after unwillfully admit it...

But before you jump to conclusions and start threatening em just try and settle it one on one with em.. best of luck mate! :D

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2909848
Share on other sites

I agree with ^^^... but if you get your insurance company involved you have to pay your excess cos your making some what of a claim... i dunno about you buy my excess is like $1500 lol

Check your policy, if you can identify the guilty party you shouldnt have to pay the excess. You only pay the excess if you are to blame (or you can not identify the third party).

Either way its worth asking your insurance company. An enquiry will cost yopu nothing.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2911786
Share on other sites

Thanx for the help guys! Im going to take some photos of the damage tomorrow then give it a high pressure clean. Hopefully i can have a leisurely chat with them tomorrow aswell, as i have been too busy climbing trees of late to do anything! thanx again, i'll keep ya's posted on how it goes

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2911794
Share on other sites

I've spoke to my mechanic and he said, hopefully telling the truth, he didn't top the battery level up. Now it could still be the alternator but i doubt it as i've never had a problem before and this did happen pretty much after the service. He did say though that they tightened the battery clamp down so i checked that and yes it was very tight. Also i noticed the battery seemed some what swollen on the sides. Like it was full off pressure, when i pushed the sides in battery acid would come out the top of the terminals! What the?? Can anyone help?

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2917056
Share on other sites

Hey Lee,

Have you thought of getting a sealed battery like a dry cell or gel cell battery?

Odysseys are pretty good and they are very low maintanance and are fully sealed.

Shaun

Thats great, but doesn't resolve my problem!

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2917308
Share on other sites

If battery is bulging its either being overcharged, vents blocked off (happens with some makes) or its getting very, very hot under your bonnet...

Given youv'e just had a service, either someones being playing with the alternator, or for some reason ran really hot.

Oh by the way, you can just use normal dishwashing liquid with water to neutralize acid.

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2917390
Share on other sites

If its been overtightened its possible he has damaged the battery.

Remove the battery clamp and check there's no noticably 'dents' on its top.

Yeah was definately overtightened cubes, when i undone the clamp it seemed a bit dented. Could this have caused the acid everywhere? I told the mechanic that it was too tight but he doesn't seem to think that would cause this! Is he just covering his arse? What should i do?

Link to comment
https://www.sau.com.au/forums/topic/156530-acid-batttery/#findComment-2917394
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Heres another fitment photo. redrilled the pattern to 5x112, and threw my audi´s rims on. had to touch the upper control arms with grinder, because the "sharp corner" was sticking about 2-3mm on the tire path. i have the "fender lip" mostly cut off, otherwise these (too) would contact with it. 20x9.5 ET25 rear    265/30 20x8.5 ET20 front    255/30 they are temporary, and look too big for the chassis. searching for 19s to it.
    • From experience, it will come back to bite you haha.
    • Background: my BMW 225i hatchback (rebodied MINI/X1) came with 3x RE003 and 1x Goodyear Asymmetric something. The RE003 roared and slid around, the Goodyear side was quiet and grippy. Definitely my car was thrashed before it got sent to dealers. My brother also got RE003 all round on his old VA WRX STI, I wasn't impressed with them, car was loud so can't comment on noise. Anyway, Hankook stopped making/updating V12 Evo2. So bought S1 Evo3 runflats. Great daily duties tyre and not that harsh ride. Tyre reviews site/youtube rated them as best stopping in the rain and I believe them. Next set, Goodyear Asymmetric 5 non-RFT. It beat PS4 in tests and is like $100 cheaper, so put them on. Great tyre, more grip then S1 Evo3 but a tad noisier as expected, still rocking them. Next set I am looking to go runflats, probably the new Hankook Evo. Although the new Pirelli PZ5 did well in tyrereviews test. Or go Goodyear Asymmetric 6 which was top tyre last year. The V12 Evo2 on my gen5 Liberty GT wagon did great in cold condition (drove to snowy mountains for a day so my husky can feel his ancestor's roots). Super impressive performance for $120 each lol. Never skimp on tyres, brakes, suspension. There's old pics of my R31's crappy random brake pads bending in the caliper at Oran Park track day somewhere around here. Anyway, my 2 cents.
    • I said "Matlab clone". I could throw one onto one of my linux VMs. Probably only take 10 or 20 hours to sort out the dependencies, relearn how to use it, etc etc.
×
×
  • Create New...