Haltech E11v2

[Bugis]

Hi All,

I just install the e11 to my r32 gtr with stock wire. Everything fine except the air-cond set-up.

Whenever I turn-on the a/c rpm will drop 150 rpm. Advise & info please.

[AWD2Go]

Hi All,

I just install the e11 to my r32 gtr with stock wire. Everything fine except the air-cond set-up.

Whenever I turn-on the a/c rpm will drop 150 rpm. Advise & info please.

What version of the Halwin software are you using 1.62 or 1.71?

In version 1.71 I found under Otions: Auxilary Outputs:

In the Auxilary or PWM outputs, there is an option to cut the A/C out above a specific TPS or RPM but haven't found a rev compensation yet.

Edited February 23, 2007 by AWD2Go

[RB30-POWER]

have you wired the standard FICD valve to turn on with the a/c compressor, its usually switched via the standard ecu. just wire it to switch with the compressor clutch.

also if you add some timing in the load cell with rpm just below standard idle, it will help reduce the drop because as the rpm tries to fall, it adds more timing and the torque increases and less drop.

going through the ecu via an input is best, but i have done the above with numerous vehicles and the idle doesn't really budge more then 25rpm with the a/c ompressor cycling on idle.

[Bugis]

I'm using ver. 1.62

[shwaier]

Hi Bugis

Can you send to me the base map Please

Thnaks

Edited May 29, 2007 by shwaier