Hdi Dual Stage Boost Controller

[Anakha]

Hey guys, just a quick one - I got a Turbosmart boost controller from Kezza on here, xept it doesn't seem to work. I'm no looking for another and found this HDI Dual stage.....

Anyone know whether these ones are any good?

[Anakha]

Bump

[4drftn]

im the same thinkin about buying a HDi there is a 3 setting one i wanna get. do's it mean its triple stage??? is there such thing? i have a dual (2) stage controller

[BAMR33]

Report Kezza to the admins. He's obviously sold it to you knowing it doesn't work, why else would he have taken it off...

If you mean the HDI boost controller below, it doesn't look too bad at all and would definitely do the job.

http://cgi.ebay.com.au/HDI-ELECTRONIC-dual...1QQcmdZViewItem

[4drftn]

im thinkin about getting a hdi electronic boost controller because it has three settings on it - factory, Preset Low and Preset High. question what is factory boost setting for the r33 (rb25t)? is it 6 or 7 pound. thanks

[Birnie]

Report Kezza to the admins. He's obviously sold it to you knowing it doesn't work, why else would he have taken it off...

If you mean the HDI boost controller below, it doesn't look too bad at all and would definitely do the job.

http://cgi.ebay.com.au/HDI-ELECTRONIC-dual...1QQcmdZViewItem

Note that this one is just a fancy bleeder with no electronic control on the level of boost.

The only 'electronic' part is the the toggling between settings.

To HOLD the boost at a certain level, you need to read what boost you are on and adjust accordingly, this item has no sensor and no ECU-unit to do the calulations.

THere is another one that does and is resoanably cheap if i can find it......

Here : http://cgi.ebay.com.au/New-HDi-Full-Electr...1QQcmdZViewItem

Personally i would do either

1) just get a single stage manual bleeder such as a Turbosmart for $50-$100

2) spend the extra $80? to get the REAL-electronic one

3) get a decent brand electronic like Blitz/Profec sent thru nengun for around $330-$350 delivered

4) oh yeah, and of course, 2nd hand of any of the pre mentioned options

[Birnie]

..and, R33 actuator standard is 5psi

What sort of Turbosmart 'dud' did you get?

Was it just a single/manual/under-bonnet bleeder?

Not much can go wrong with them.

Have you set it up right?