Fitting A Cat Back System On R33

[jerry]

Do you need any special tools or can i do this job at home. I am looking to buy a 3" XFORCE CAT back (angled) exhaust system. Do i require any further tools (welding etc)? Wouldn't mind doing it at home if its easy. Looks easy. But i am not sure if the angled exhaust requires more work.

Thanks in advance guys.

[jerry]

Also, Does the Angled system sit lower to the ground?

[Mikyel]

how are you planning to get under the car firstly..

advise is better to go to a mechanic.. some will do a proper job and safer for you.

if its bolt on exhaust system than you dont need any welding

[rgr34]

shouldn't be hard it all bolts.... need some stands or even ramps to get under the car....

Edited March 19, 2007 by rgr34

[Cooper]

Very easy to do, as said above its just bolts and a few rubber mounts. Just make sure the car is safe to be under ie use ramps or axel stands

[jerry]

shouldn't be hard it all bolts.... need some stands or even ramps to get under the car....

Yeah i have jack and stands. Cool. I suspected it was all bolts and nuts. Does the angled exhaust sit lower?

[MANWHORE]

get it up a bit so you can get under it and it's easy as. Bolts might be a bit tight, but just use your manpower.

[subzeroR33]

Its a pain in the arse tight squeeze under there, but pretty easy once its fitted a couple of gaskets and four bolts.