Electrical Oil Pressure Gauge, Autogauge

[black sky]

Hi People

I was just wondering how i would install this?? do i need the sandwich plate or does it get it's input electronically

this is the product.

http://cgi.ebay.com.au/Auto-Gauge-Smoke-ST...1QQcmdZViewItem

Cheers

anthony

[Omurru]

It has a pressure sender unit, (little round cylinder thing) which you screw in somewhere and it sense's the oil pressure and sends an electronic signal back to the gauge.

Installing it there are a few options, you can either remove the stock sender and replace it with the new one but then your dash gauge will no longer work.

A sandwich plate on the filter is probably the easiest but check and make sure before hand there is room for the sender to screw into it, this will also make it easier if you want to install an temp gauge as well.

The other way to go it is to go down to somewhere like HIS hose and get a T piece with one male and 2 female fittings to suit (will have to be male on one end of the T and female on the in and other end of the T, clearance thing again)

Personally i'd go the sandwich plate route. Means all the stock stuff is left alone and it's more shinny stuff for your engine