Jump to content
SAU Community

Extrude Hone

ovabooster

By ovabooster,
in Engines & Forced Induction

 Share

Recommended Posts

ISL33P Proficient

ISL33P

Posted
Posted

Hi Hoang, for the most accurate response, i would call the company who does this sort of work. They would be the most knowledgeable/honest persons when it comes to this, and since a lot of info on forums are secondhand, it would be highly recommended.

OVL-747 Enthusiast

OVL-747

Posted
Posted

it wont increase spool times

but what it will do is increase effiency of the air to move thru the comp cover

the air wont cavitate on itself over the harsh rough wall.

think of running your fingers over 150grit sand paper as opposed to running them over normal computer paper , what would u prefer to do at high speed for a lengthy amount of time.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • tomaytown
      Skyline R34 Non- Turbo

      By tomaytown · Posted

      Uhhh if anyone sees this - I bought a BRZ years ago, on my fulls soon so back on the market for the R34!
    • The Bogan
      newbie attempts the GTR life.

      By The Bogan · Posted

      Research research research, and tackle the important things first, like the rust, because as a wise old hippie and some crazy horses once said "rust never sleeps" Nothing good comes easy and fast, and nothing that comes easy and fast is typically good
    • The Bogan
      Using Trickle Chargers

      By The Bogan · Posted

      I made an extension of the item circled above in red that is hard wired to the battery and tucks away nicely in the engine bay, could easily do the same if it in the boot, just run the extended cable out under the bonnet or boot lid, I then just stick the charger on a milk crate to get it off the ground
    • MBS206
      RB25 Oil Pump Regulator Washer???

      By MBS206 · Posted

      It's purpose will be to stop the regulator plug from leaking oil. As GTS said, if it seals properly, it will mainly just have the effect of slightly higher oil pressure. I'll assume tolerances/fitment in the relief valve aren't that close that the washer being missing won't let it vent at 100% capacity too.
    • GTSBoy
      Using Trickle Chargers

      By GTSBoy · Posted

      I put the charger in the engine bay and run the power cord down through one of the holes in the undertray, or at the back end of the engine bay, any time I need a car to be on a charger outside. In fact, I bring the extension cord up through into the engine bay so that it's not dragging around where it could get wet, or easily unplugged.
×
×
  • Create New...