Jump to content
SAU Community

Recommended Posts

hey guys have a few this i just want to get rid off that have been taking up space

set of 18 by 8.5 inch rims the have afew marks and scratches on them and the front left has a gutter scratch in it i have 225 by 40r nankanges on the front that are 3 months old and cost me $320 the back have camber were so the will need to be changed i dont know exactly what the rims are called as i bought them with the car, they can do with a good clean in the photo they are dirty

SOLD

s2 type m front lip brand new $250 pick up

a s2 steering wheel with the airbag in it the leather is slightly peeling where you hold the wheel from wear and tear, no rips

$100 local pick up or i will send a buyers expence

i also have 400r side skirts for a r33 they are brand new never used

SOLD

located in sydney, earlwood

post-26301-1176544284.jpg

post-26301-1176544313.jpg

post-26301-1176544339.jpg

post-26301-1176544498.jpg

post-26301-1176693765.jpg

post-26301-1176693781.jpg

Edited by xxx_25L
Link to comment
https://www.sau.com.au/forums/topic/164548-rimsskirtssteering-wheel/
Share on other sites

howdy, im really interested in the 400r side skirts,new-- so they havent been painted? i noticed it said pick up only, would you considrer sending interstate? plus any chanche of seeing a good pic or two? cheers Damo

Mate those rims look nice.. Question is what offset they are.. they look quite high sitting about 40mm from the hub .. unless your driving a GTR.. could you find out for me and let me know via pm .. I live canturbury so keen as ..

Any pix on those scratches too?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...