Jump to content
SAU Community

Recommended Posts

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Thanks mate. Your responses are as fast as your car.

you can just see pauls head gettin bigger :D

what steve said is right, put the exhaust on and have a quick dyno run to check the AFR's. if theyre rediculously rich then maybe consider an AFC. you can get one of the older series ones for around the $150 mark

Link to comment
https://www.sau.com.au/forums/topic/16458-safc/page/2/#findComment-339418
Share on other sites

I can't say that the map I used when going to the dyno was any evidence of a good tune. My afr's above 120kmh in 4th were super rich. I did mean to make them that way to minimise the ping issue. Otherwise the afr was around 12 which aint bad for a road tune.

The dyno resulted in 230 something HP at 130kmh, whatever that is in rpm (I am guessing 4700rpm) before the ping comes in.

I've got a 600HP fuel pump in now and things seem a little better coming onto the throttle than before too.

Link to comment
https://www.sau.com.au/forums/topic/16458-safc/page/2/#findComment-341338
Share on other sites

aftermarket management would be the way to go and possibly a boost controller, then before u start playing with bigger turbos, have to consider, upgrading fuel system, and rebuild engine with stronger internals so it can cope with the power level and higher boost levels that bigger turbos produce :)

if you don't want a full on ecu, get an apexi safc or safc II which is a piggy back air fuel controller, i just got mine unitl i can afford a full on ecu :)

adrian :P

Link to comment
https://www.sau.com.au/forums/topic/16458-safc/page/2/#findComment-346824
Share on other sites

adrian, how much did the apexi safc2 cost you and what better performance are you getin out of it?? Wheres the best place to buy one from and who do you reckemond to work on cars, i took mine to Tim Sleko to get a GFB boost controller put on (now at 10 psi), and take off the fuel regulator cause it was running too rich.

Matty P R34

Link to comment
https://www.sau.com.au/forums/topic/16458-safc/page/2/#findComment-348362
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Hey Duncan, I've always set them up from 6 -> 1. Due to slightly higher EGT's, I also add a small amount of fuel to cylinder 6 & 5. I understand why you start at 6 but curious as to why you then continue somewhat based on firing order? Thanks
    • United E85 is always 85% ethanol. At least it claims to be. But that goes out of the window about thirty seconds after you put a tank of it into your car and can't do the math to determine if you have 76% ethanol, or 47% ethanol or 26% ethanol because you put 33L in, then 16L in, then a full tank of 98, then "Some" E85. Ethanol tunes that aren't full flex or full E85 all the time are just absolutely a waste of time. Don't be stupid and ruin your car.
    • I don’t mean this in any negative way. But, if u are after this type of data why don’t u have a flex fuel sensor?
    • So what now? Enjoy it and go cruising or more modifications? Few meets/cruises happen in the west every now and then, should definitely take it out.
    • The issue still requires a human to get all the logic right, and each thing being done takes up processing power. Meaning less processing power for other tasks to occur too. It also typically means a team of size 10, is working one everything, vs 5x teams of 3 working on separate products, so less man power to review and perfect it all.   That's the typical issue of AIO. It's also why manufacturers of cars even split tasks out into separate systems, and share data as required
×
×
  • Create New...