Jump to content
SAU Community

Recommended Posts

Just wondering if removing this 2 stage thing is hard and how to do it. Is it even worth it cause ive been advised that having lower boost for launch would be better for traction. Lastly is removing this 2 stage boost control is it detrimental to the engine at all??

Link to comment
https://www.sau.com.au/forums/topic/164724-removing-r33-2-stage-boost-thing/
Share on other sites

yeah search for it.....i did it myself.....in a nutshell you need to 1 wire and ground it.....very simple. cant imagine it will do any damage as you hit full boost after 4500rpm...and ppl run up to 12psi on stock turbo and even higher on stock internals....give it a go....at ur our risk of cousre!!!!

So for example when you get an EBC does the 2 stage still apply???

If you use an EBC, the standard 2 stage boost is no longer utilized.

The mod in the diy section is very easy and makes a bit of a difference. the car feels stronger and petrol consumption increases (in my car) by about 1 litre per 100ks.

yeh just do the mod easy as... altho it didn't work on my car :P If you remove the solenoid you'll only get low boost (5psi) unless you have a boost controller.. I'd say do the mod or just leave it and practice your launching. you might just be reving to high when you drop the clutch :banana:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I was more thinking so it doesn't flop around as much rather than for rotating it. Once you have the balance right, it should rotate well enough, depending on how much resistance there is on the pivot. I think you said the pivot point was on a bearing though didn't you?
    • You can get them with the worm drive rotator but I was too tight to pay another $250-$300 so manual labour it is! I don't think it will be too hard to rotate though. 
    • Sag as in the windows start to slowly open themselves, or they're just slow to go up/down with engine off?
    • It looks like it needs a big worm gear drive on it to control the rotating, not a few sloppy pins!
    • As Duncan said, first there was OBD, which few cars used, then came OBD2.   Now an interesting point, OBD2 isn't even for what you want to do. OBD2 is for emissions testing. There is some sensor data on OBD2, but it's up to the manufacturer what they're putting on it. Most scan tools operate on UDS, which like OBD2 is a standard built on-top of CAN. UDS specifies how to structure a message, what very limited things mean such as "read memory address" but it does not specify what is stored in which memory address, that is all up to the manufacturer. You either a scan tool compatible with that vehicle, or to know how to reverse engineer all the data, which can take a VERY long time and a lot of vehicles to get it right. Oh and then the manufacturer does a firmware update and changes what's where... Ask me how I know that as fact Oh, and by the time you've got the scan tool that supports all the manufacturers stuff, well, you're back at "But a consult cable and the Nissan software" The main difference being most manufacturers software these days works with the same hardware readers, as the readers are built to support J2534 which is another standard for how the PC communicates with the tool to make it do specific things on the car...
×
×
  • Create New...