Jump to content
SAU Community

Recommended Posts

i was wondering if installing a safc will make a big dirrernce i curently have

- air pod

- zorst

- intercooler

-boost controller

- fuel cut defender

on this setup i made 198kwrw on 11 psi i was looking for abit more power around 15kw i was wondering what gains i will get from a safc and can it be used with a fuel cut defender or is it piontless

thanks

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/
Share on other sites

i was wondering if installing a safc will make a big dirrernce i curently have

- air pod

- zorst

- intercooler

-boost controller

- fuel cut defender

on this setup i made 198kwrw on 11 psi i was looking for abit more power around 15kw i was wondering what gains i will get from a safc and can it be used with a fuel cut defender or is it piontless

thanks

not pointless at all with your setup. The SAFC is the entry point to engine management. I'm no expert but a good tuner may squeeze 15+kw gain over the stock ECU map at a guess.

IN the old days when I ran an e-manage, only cat back zorst & R34 SMIC upgrade I had gains of that order. I was initially running the same, but stock boost of 7psi and it went from about 155-160 to 175 with the Emanage which does essentially the same thing as the SAFC.

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/#findComment-3072897
Share on other sites

It works by tricking the ECU into thinking it's got a different amount of airflow which than allows you to add/remove fuel and lean it closer to 12:1 AFR... Problem is, it just changes where on the fuel/ignition maps it is, so timing is changed accordingly which can cause issues..

Good if you don't have enough for a PFC and using stock turbo.. should get around ~200kw with average mods as above..

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/#findComment-3074374
Share on other sites

Went the SAFC after all hey?

That's OK, so did I initially and there's nothing wrong with that.

just don't pay too much for installation if you're getting someone else to do it.

If you're on a budget, ask around on the forums and get someone to do it for you.

When i sold my SAFC-II 2 years ago (?) i also installed it for the guy for a case of beer.

Bit fiddley but not too hard.

Good luck with it, and if you can, ask the tuner for a before and after printout and post it up.

:P

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/#findComment-3074409
Share on other sites

haha yeh mate decided to go the safc. decided to opt out and go the budget way and up the payments on my loan and get it out of the road and also start saving up some cash for future house. power fc wouldve been great but didnt have the dough.

yeh looking around the albury area for a tuner. anyone had any experience with anyone around that area??

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/#findComment-3074423
Share on other sites

Went the SAFC after all hey?

That's OK, so did I initially and there's nothing wrong with that.

just don't pay too much for installation if you're getting someone else to do it.

If you're on a budget, ask around on the forums and get someone to do it for you.

When i sold my SAFC-II 2 years ago (?) i also installed it for the guy for a case of beer.

Bit fiddley but not too hard.

Good luck with it, and if you can, ask the tuner for a before and after printout and post it up.

:P

its in the manual and u can download it.

Link to comment
https://www.sau.com.au/forums/topic/165917-safc/#findComment-3074458
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • That's a short. Find the short. It will be somewhere between that fuse and the headlight. Start by removing the plugs from the back of the headlight and dimmer switches, and measure resistance to earth. Supply side (power from the fuse) should have none. The other side should have resistance compatible with whatever globe(s) is there (which is relatively easy to say for a normal globe, perhaps not as easy to say for LEDs). Anyway, if you have very low resistance, you defo have a short. Then you just have to run the wiring like you're running the bowel of a dog (on the operating table) that has swallowed something it wasn't supposed to.
    • Hey guys, need help figuring out why my driver side (RH) fuse 15amp keeps blowing. The Driver Sides Headlamp is out, i replaced these a long time ago with LED ones that were working for 1-2 years. Now, the driver side light is out and i traced it back to a broken fuse. I replaced the 15 amp fuse in the engine bay and as soon as i flip the headlight on, it blows the new fuse. Any idea what's going on?
    • I found the same with Subaru’s.  I own and love the SG9 Forester, after that model 2008+, Subaru threw the ugly stick at all their line up and somehow managed to make them look worse with every succeeding year.  lol
    • It's something we all have to consider as time marches on. Also consider lifted rally MX5 conversion at that point.
    • I should be fine for a few more years, whilst I do have arthritis I also exercise and do mobility training every day to keep as fit and healthy as I can, military life, which is the actual cause of most of my joint issues, has set daily regimes, which I weirdly enjoy I also train alot smarter now, not really focusing on lots strength or puffy muscles, I'm more focused on maintaining what I have for my future older self, I actually train as much mobility now as I do exercising Check out this "simple" drill I have been doing daily prior to training now for a while now, this has worked wonders in my all round mobility   
×
×
  • Create New...