Jump to content
SAU Community

Recommended Posts

I think the part number is the same as the for R32 GTR, the part no. can be found on the bendix site.

I have heard the EBC greenstuff are supposed to be pretty good, but they are a fair bit dearer from the prices I got the other day.

Link to comment
https://www.sau.com.au/forums/topic/16692-brake-pad-part-no/#findComment-343125
Share on other sites

Originally posted by slip

depends on how you drive.  I personally wouldnt use ultimates again, but if you dont drive / brake hard, they will probably be fine, but then again, so will most pads.

Just been for a squirt around Sandown, and the Ultimates worked just fine.
originally posted by red900ss

Champinco, trimmed your multiple threads asking the same question down to this one

Maybe you could trim out the multiple postings in this thread :P
Link to comment
https://www.sau.com.au/forums/topic/16692-brake-pad-part-no/#findComment-344196
Share on other sites

thanks guys for the info and sorry about the multiple threads it was an accident. it would upload the message but not show it.

with regards to the pads, i went to autobarn and they didnt know which ones they were. and they didnt want to order them unless i knew the number. they searched the catalogue and all and they still didnt know which ones fit. i guess now i know.

ill order the db 1170 ult & db1220 ult

Cheers

Link to comment
https://www.sau.com.au/forums/topic/16692-brake-pad-part-no/#findComment-344230
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...