Rb25det Wont Start? Help Asap

[LINCNDLOZ]

how do i test my cas as ive got no spark and no injectors. car ran fine before i pulled engine out? help

Come on some one must know?

Edited May 21, 2007 by LINCNDLOZ

[LINCNDLOZ]

by the way its an rb25det

[tacker]

would be checking fuses first

[Adriano]

Check for power at the injectors first, heap easier than checking the CAS without an oscilloscope

[LINCNDLOZ]

injectors have power, coil packs have power. if i earth the injector wire at the ecu that injector fires. if i power up the no1 or 2 etc spark signal wire at the ecu that plug fires as well?

[Adriano]

Sounds like cas. you could remove the cas from the front of the motor, leaving it plugged in, figure out which pins are power, earth and the 2 sensor wires. put your meter on the sensor wires, and turn the cas over slowly by hand, the volts should go up to 5v and down on both channels at different times.

[LINCNDLOZ]

Has anyone done this with a ohm meter?

[Adriano]

Needa volt meter

[LINCNDLOZ]

I will try this and see what happens? thanks